Advertisement
If you would like to assemble a plastic clip on your PB-07 you can use a 4 mm screw up to 5 mm inside of the PB-07
case. Do not use longer screws as to prevent touching the connectors and damaging them.
The Optogate devices were developed for use in connection with professional equipment and should be used by
professional system engineers and operators only. Please be aware that we are not responsible for any hazards,
damages or disadvantages due to the using of the Optogate devices. The Optogate devices are registered under the
number DE54933725 WEEE as B2B devices. We also declare that they conform to the CE and ROHS for the
European market. If you have further questions please don't hesitate to contact us at:
info@optogateamerica.com
Typical operating instruction
1. Plug in the Optogate
2. Run phantom power to the mic (their will most likely be a switch on your mixer for this, almost all mixers
have these)
3. Click the bypass switch on top of all of the Optogates you are using and dial in the PA for the best tone and
gain before feedback with the optogate bypassed ...ie. mics are on, light stays on no matter where you are
physically)
4. Click the bypass switch again and activate the Optogate (light/mic turns off when out of range)
5. With a small screwdriver set the distance you want the Optogate to turn on/off (based on your mic
technique)
6. Your done!, you will now have way better sound than you are used to hearing...it's that simple....
Advertisement
