Ieee 1394 Port; Headphone Jack; Microphone Jack; External Monitor Port - Fujitsu Lifebook S6231 User Manual

L i f e B o o k S 6 0 0 0 N o t e b o o k
Figure 4-18. Connecting a USB Device

IEEE 1394 PORT

The 4-pin 1394 port allows you to connect digital
devices that are compliant with IEEE 1394 standard. The
IEEE 1394 standard is easy to use, connect, and discon-
nect. This port can allow up to 400 Mbps transfer rate. A
third-party application is required to operate your
digital device with the 1394 port
The 1394 port used in this system uses a
four-pin configuration. If you intend to
interface with devices which use a six-pin
configuration, you will need to purchase
an adapter.
In order to connect a 1394 device, follow these steps:
1. Align the connector with the port opening.
2. Push the connector into the port until it is
seated.(Figure 4-19)
Figure 4-19. Connecting an IEEE 1394 Device

HEADPHONE JACK

The headphone jack (Figure 4-20) allows you to connect
headphones or powered external speakers to your note-
book. Your headphones or speakers must be equipped
with a 1/8" (3.5 mm) stereo mini-plug. In order to
connect headphones or speakers follow these steps:
1. Align the connector with the port opening.
2. Push the connector into the port until it is seated
If you plug headphones into the
headphone jack, you will disable the built-
in stereo speakers.
46
.
.
Figure 4-20. Connecting Headphones
If you plug headphones into the head-
phone jack, the built-in stereo speakers
will be disabled.

MICROPHONE JACK

The microphone jack allows you to connect an external
mono microphone. Your microphone must be equipped
with a 1/8"(3.5 mm) mono mini-plug in order to fit into
the microphone jack of your notebook. In order to
connect a microphone follow these easy steps:
(Figure 4-21)
1. Align the connector with the port opening.
2. Push the connector into the port until it is
seated.
Figure 4-21. Connecting a Microphone

EXTERNAL MONITOR PORT

The external monitor port allows you to connect an
external monitor. In order to connect an external monitor
follow these easy steps: (Figure 4-22)
1. Open the flexible cover over the external monitor
port.
2. Align the connector with the port opening.
3. Push the connector into the port until it is seated.
4. Tighten the two hold-down screws, located on each
side of the connector.