Summary of Contents for SereneLife SLSPA4SQA
- Page 1 SLSPA4SQA - SLSPA4RND - SLSPA6SQA - SLSPA6RND Inflatable Pool Spa with Light Portable Hot Tub Spa with Light and Remote Control...
-
Page 2: Table Of Contents
CONTENTS Safety Instructions Parts Checklist Before you setup your In atable Pool Spa Setting up How to setup the Ambient LED Lighting Operation Maintenance & Repair Cleaning & Storing away Troubleshooting Features and Technical Specs SAFETY INSTRUCTIONS - READ CAREFULLY! When installing and using this electrical equipment, there are basic safety precautions that should always be followed: •... - Page 3 • Soaking in hot water during pregnancy can cause damage to the unborn foetus. If you have any speci c concerns please consult your doctor before continuing to use your hot tub. • Use of alcohol, drugs or medication before or during use of your In atable Pool Spa can increase risk of drowning.
-
Page 4: Parts Checklist
PARTS CHECKLIST Please check all parts are present in your box before rst use. To order new or missing parts please visit: SereneLifeHome.com GROUNDSHEET (A) FILTER CARTRIDGES (B) FILTER PROTECTOR COVER (C) INFLATION HOSE (D) CLIP-ON TOP COVER (E) REPAIR PATCHES (F) DRAINAGE PLUG (G) SAFETY LOCKING CLIP KEYS (H) LED LIGHTING KIT... -
Page 5: Setting Up
SETTING UP Before setting up your In atable Pool Spa with LED Lights It is important to check your lights are working before setting them up. Please note: You must insert the lights through loops on the base of hot tub before lling up with water. - Page 6 Unscrew cap from Air Screw Hose (D) on to Unscrew outer cap from In ation Valve (K). Do not Outlet (J). Air Outlet (J). unscrew the black inner valve. Push the Hose (D) into Press ‘In ate/Air Jets’ on To aid the in ation pull the In ation Valve (K).
-
Page 7: How To Setup The Ambient Led Lighting
Screw Filter Cartridge (B) Add Filter Protector Cover Add water to level. onto Filter Connector (N). (C) onto Filter Cartridge (B). No higher than ‘MAX’ level. Set temperature on control Double lock clips with panel*. Clip on Top Cover Safety Locking Keys (H). (E) to retain the heat. - Page 8 HOW TO INSTALL LED LIGHTING LIGHT KIT PARTS First Last Start/End lighting Lighting Lighting equally spaced Loop Loop Ensure lighting is not tight between loops and LEDS face the base HOW TO USE YOUR LED LIGHTING RF REMOTE CONTROL INSTRUCTIONS A.
-
Page 9: Operation
INITIAL LIGHTING SETUP 1. Connect lighting system together as shown on page 8. 2. Remove plastic tape from the battery compartment on the remote. 3. Turn lights on with the power button. If colours pressed on the remote are activating incorrect colours on the light strip: 1. -
Page 10: Maintenance & Repair
FILTRATION SYSTEM: Press ‘FILTER’ , red light will appear, pump will start to work. Press ‘FILTER’ again to stop pump, red light will go out. After approx. 168 hours, ‘FC’ will appear on display screen ( ashing), with a warning tone. Red light will be lit on ‘FILTER’ , pump will not be operational. -
Page 11: Cleaning & Storing Away
CLEANING YOUR INFLATABLE POOL SPA Detergent residues, dissolved solids from bathing suits and chemicals will gradually accumulate in the water. To clean your In atable Pool Spa, use soap and water then rinse thoroughly. Please note: DO NOT use hard brushes or abrasive cleaners. REPAIRING PUNCTURES IN YOUR INFLATABLE POOL SPA If your In atable Pool Spa is torn/punctured, use repair patches. - Page 12 STORING YOUR INFLATABLE POOL SPA Make sure all the water is completely drained from the In atable Pool Spa and pump system. This is vital in extending the life of your In atable Pool Spa. We recommend the use of a wet/dry vacuum to blow out or suck up water from the In atable Pool Spa pipes and pump lines.
-
Page 13: Troubleshooting
A3 Air Pump in cooling mode A2 Wait for 10 Minutes and restart A3 Call SereneLife Aftersales if does not reset A1 Temperature is set too low A1 Set to a higher temperature 20-40°C... - Page 14 Water temperature will be operational. Heating system will not work, displayed, all functions will return to and red light will be out on heater. normal. Contact SereneLife Aftersales on: SL/HL Temperature Issue www.SereneLifeHome.com Contact SereneLife Aftersales on: Water Temperature Sensor Issue www.SereneLifeHome.com...
-
Page 15: Features And Technical Specs
FEATURES AND TECHNICAL SPECS MODEL SLSPA4SQA SLSPA4RND SLSPA6SQA SLSPA6RND High Powered Bubble Jets Seating Capacity 4-Seat 4-Seat 6-Seat 6-Seat Water Capacity 600L/158 Gal 800L/211Gal 910L/240Gal 1000L/264Gal Bubble Jets Product Dimensions 57'' x 57'' x 25'' 73'' x 73'' x 25''... - Page 16 Questions? Issues? We are here to help! Phone: (1) 718-535-1800 Email: support@pyleusa.com...
Need help?
Do you have a question about the SLSPA4SQA and is the answer not in the manual?
Questions and answers