Page 3
Please read this user manual first! Dear Customer, We hope that you get the best results from your product which has been manufactured with high quality and state-of-the-art technology. Therefore, please read this entire user manual and all other accompanying documents carefully before using the product and keep it as a reference for future use.
Page 4
Please read this user manual first! Dear Customer, We hope that you get the best results from your product which has been manufactured with high quality and state-of-the-art technology. Therefore, please read this entire user manual and all other accompanying documents carefully before using the product and keep it as a reference for future use.
Instructions for safety and envIronment This section contains safety Never touch the plug with • instructions that will help to give wet hands! Never unplug by protection from risk of personal pulling on the cable, always injury or property damage. Failure pull out by grabbing the plug.
Instructions for safety and envIronment to be used in household and Store all detergents and • similar applications such as: additives in a safe place - Staff kitchen areas in shops, away from the reach of the offices and other working children.
Instructions for safety and envIronment Compliance with WEEE collection points designated by the local authorities. Directive and Disposing of the Waste Product This product complies with EU WEEE Directive (2012/19/EU). This product bears a classification symbol for waste electrical and electronic equipment (WEEE).
Dishwasher Technical specifications Compliance to standards and test data / EC declaration of conformity This product complies with the following EU directives; Development, production and sales stages of this product comply with the safety rules included in all pertaining European Community regulations. 2014/35/EU, 2014/30/EU, 93/68/EC, IEC 60436/DIN 44990, EN 50242 Power input 220-240 V, 50 Hz (see rating label)
Installation To make the product ready for use, Do not install the product at places • make sure that the electricity, tap water where temperature may fall below 0ºC. supply and water drainage systems are Place the product on a rigid floor. Do •...
Installation Connection to the drain Drainpipe must be connected to the foul water system and it Water discharge hose can directly be should not be connected to any connected to the drain hole or sink’s surface water drain. drainage. The length of this connection must be min.
Installation This appliance must Green and yellow be earthed or green If the fitted moulded plug is not suitable for your socket, then the plug should be cut off and an appropriate plug fitted. Destroy the old plug, which is cut off as a plug with a bared cord could cause a shock hazard if inserted into a socket...
Preparation Tips for energy saving Adjusting the water softening system Following information will help you use the product in an ecological and energy- Cleaning, rinsing and drying performance of efficient manner. your dishwasher will increase when water Wipe away any coarse food remnants on softening system is adjusted properly.
Page 15
Preparation 1 min. 1 Second 1 Minute Remove the test Turn on the tap and Hold the test strip in Remove the test Wait for 1 minute. The test strip shows strip from the let the water run for the water for about strip from the water you the hardness packet.
Preparation If the hardness level of the supply water It is recommended to use is above 90 °dF or if you are using well granule- or powder-formed water, then it is recommended to use water softening salts in the water purification devices and special filters.
Preparation Since different salt brands in the market have different particle sizes and since the water hardness may vary, dissolution of the salt in water may take a couple of hours. Therefore, Salt Indicator remains on for a while after adding salt into the machine.
Preparation Push the latch to right to open the 3. Push the lid of the detergent dispenser detergent dispenser lid (A). to close it. A "click" will be heard when the lid is closed. 2. Put suggested amount of powder, liquid/gel or tablet detergent in the reservoir.
Preparation together with the detergent if the water Rinse aid hardness level is above the mentioned level. The rinse aid used in The best washing performance dishwashers is a special in dishwashers is obtained by combination that aims to using detergent, rinse aid and increase drying efficiency and water softening salt individually.
Preparation Placing the dishes into the 4. If there are stains on tableware items after washing, level must be increased dishwasher and if there is a blue trace after wiping You can use your dishwasher in the them by hand, it must be decreased. optimum way with respect to energy This is set to position 3 as factory consumption and washing and drying...
Page 21
Preparation Suggestions for loading the dishwasher Improper Loading Of Dishware Lower basket Upper basket Improper Loading Of Dishware 19 / 42 EN Dishwasher / User’s Manual...
Preparation Adjusting the height of the Hold the upper basket wires with both hands, slightly lift up the basket and upper basket simultaneously push and release the The upper basket height adjustment latches shown in the figure (B). mechanism has been designed for you to 2.
Preparation Upper basket height Collapsible upper basket adjustable rack wires Use the lower and upper parts of the height You can use collapsible wires when you adjustable racks in the upper basket of need a larger space for your dishes in the the machine by sliding them down or up upper basket of your machine.
Preparation Collapsible lower basket Bringing the tines to the horizontal position by holding tines them from the tips may cause There are foldable tines (A) located at the them to bend. Therefore, it lower basket of the machine are designed will be appropriate to bring the tines in the middle to horizontal for an easier placement of large pieces such...
Preparation Ceiling cutlery basket Ceiling cutlery basket is designed to wash your cutlery items such as forks, spoons and etc. by placing them between the bars on the basket. When the central tray is in the lower position, you can load long/high items such as coffee cups, ladles, etc.
Operating the product On/Off key 2. Programme Selection / Programme Cancel (3 seconds) key 3. Function keys Half Load Function Fast+ Function SteamGloss Function AquaIntense Function 4. Programme indicator 5. Salt indicator Not in use 7. Start / Cancel indicator 8.
Operating the product Keys Programme selection On/Off key Press the On/Off button to turn on When you press On / Off key, indicator lights your machine. illuminate on the display for ON position. 2. Check the Salt and Rinse Aid indicators The lights turn off in OFF position.
Page 28
Operating the product /42 EN Dishwasher / User’s Manual...
Operating the product Auxiliary functions AquaIntense Function AquaIntense impeller Washing programmes of your dishwasher located under the are designed to obtain the best cleaning lower impeller helps effect, considering the type of the soiling, washing your heavily soiling degree and properties of the dishes soiled dishes places in to be washed.
Operating the product Interior Lighting Changing Warning Sound Volume (Depends on the model) After turning on the machine, Some models have interior lighting to press Time Delay and P / P+ keys illuminate the interior when the door is simultaneously. Keep them pressed opened.
Operating the product 4. Close the door of your machine after Your machine performs water setting the Delayed Start. Once softening depending on the the delay time is over, the selected hardness level of the supply programme will start automatically. water.
Operating the product No rinse aid dispensed in P:0 wash position. There might be residues of 1 dose of rinse aid is dispensed in P:1 detergent or rinse aid in the position. machine and/or on the pieces 2 doses of rinse aid are dispensed in P:2 being washed depending on the position.
Operating the product Water cut-off warning If mains water is cut or water inlet tap is turned off the machine cannot take water in and E:02 icon will flash on the programme indicator. As long as the problem continues, washing programme is paused and the water inlet is checked regularly by the machine;...
Maintenance and cleaning Cleaning the filters Service life of the product extends and frequently faced problems decrease if it is Clean the filters at least once a week in order cleaned at regular intervals. for the machine operates efficiently. Check if Unplug the product and turn off food residues are left on the filters.
Maintenance and cleaning Cleaning the hose filter Damages on the machine that may be caused by impurities coming from the urban supply water or your own water installation (such as sand, dirt, rust, etc.) can be prevented by means of the filter attached to the water inlet hose.
Maintenance and cleaning Cleaning the impellers Upper impeller Clean the impellers at least once a week in Check if the holes on the upper impeller (1) order for the machine operates efficiently. are clogged. If they are clogged, remove and clean the impeller. Turn its nut to left to Lower impeller remove the upper impeller.
Troubleshooting Machine does not start. • Power cable is unplugged. >>> Check if the power cable is plugged in. • Fuse is blown. >>> Check the fuses in your house. • Water is cut. >>> Make sure that the water inlet tap is open. •...
Page 38
Troubleshooting • Rinse aid is not sufficient. >>> Check the rinse aid indicator and add rinse aid if necessary. Increase the rinse aid setting if there is enough amount of rinse aid in the machine. • Machine is unloaded right after the programme is over. >>> Do not unload your machine right after washing process is completed.
Page 39
Troubleshooting the machine. Since the salt granules that will remain under the lid will dissolve during prewash, causing the lid loosen, check the lid once again at the end of the programme. There is a different odour in the machine A new machine has a peculiar odour.
Page 40
Troubleshooting Detergent remains in detergent dispenser. • Detergent dispenser was damp when adding detergent. >>> Make sure that the detergent dispenser is dried well prior to filling it with detergent. • Detergent is added long before the washing process. >>> Pay attention to add detergent shortly before start-up of the washing.
Page 41
Troubleshooting A smear remains on glasses that resembles milk stain which can not be removed when wiped by hand. A bluish / rainbow appearance occurs when the glass is pointed to light. • Excessive rinse aid is used. >>>Lower rinse aid setting. Clean the spilled rinse aid when adding rinse aid.
Machines, Dishwashers and Electric The cost of functional replacement • parts, but excluding consumable items. Cookers The labour costs of a Beko approved Gas Cookers must only be installed by • • repairer to carry out the repair a Gas safe (or BORD GAIS) registered Gas Installer.
Page 43
If you have purchased an extended guarantee please refer to the instructions contained within the extended guarantee agreement document. Otherwise please call the appropriate number above where service can be obtained at a charge. Should you experience any difficulty in obtaining service please contact the Beko Customer Help-Line. Tel: 0845 6004911 e-mail: service@beko.co.uk...