Panasonic DoubleFeature PV-D4734S Operating Instructions Manual page 53

*Important: If a remote control button does not work when pressed,
Audio Output (DVD only)
Select the digital output to be output from the optical
digital audio output connector of DECK.
1 Press ACTION
to display DVD MAIN MENU.
2
DVD MAIN MENU
DISC LANGUAGES
AUDIO OUTPUT
ST I L L MODE : AUTO
TV MODE : 4 : 3 P a n & S c a n
PROGRESSIVE OUT : OFF
SELECT :
SET : SET
END : ACTION
3
AUDIO OUTPUT
LPCM(DVD) : OFF
D o l b y D i g i t a l : B i t s t r e a m
d t s : B i t s t r e a m
DRC : OFF
SELECT :
SET : SET
END : ACTION
I I I I I "LPCM (DVD)" selections
OFF: Linear PCM of less than 48 kHz/16 bit is
output. When playing DVDs recorded in linear
PCM of over 48 kHz/20 bit, no digital audio is
output. (Factory preset)
PCM: When playing DVDs recorded in linear PCM of
48 kHz/20 bit/24 bit or more, digital audio
converted to 48 kHz/16 bit is output.
(Digital output of PCM audio is restricted to
48 kHz/16 bit or below for copyright
protection.)
I I I I I "Dolby Digital" selections
Bitstream: Dolby Digital bitstream (1 ch - 5.1 ch)
is output. (Factory preset)
PCM: When you have connected an amplifier that
doesn't have a built-in Dolby Digital decoder.
I I I I I "dts" selections
Bitstream: DTS bitstream is output. (Factory preset)
PCM: When you have connected an amplifier that
doesn't have a built-in DTS decoder.
I I I I I "DRC (Dynamic Range Compression)"
selections
OFF: Normal audio range is selected. (Factory preset)
ON: For dynamic sound even at low volume,
this is useful for late-night listening.
[Dolby Digital DVDs only].
4
Press ACTION to redisplay DVD MAIN
MENU and go to step 2 to setup another
item.
Or, press ACTION twice to exit.
press the DVD button on the remote and try the button again.
Press
to select
"AUDIO OUTPUT,"
and
press SET
to display screen.
Press
to select an item,
and
press SET
repeatedly for
output. (See below.)
Ready Checklist
DECK is in DVD mode, press DVD.
Type of amplifier
to be connected
( DV D )
No amplifier is connected
AV amplifier (with digital
audio input connector)
without Dolby Digital/DTS
decoder
AV amplifier including
Dolby Digital decoder
AV amplifier including
Dolby Digital/DTS decoder
• Make settings according to amplifier
connected to optical audio output as
shown in above table.
*1 When connecting an amplifier (with an
optical digital input connector) which
does not contain the Dolby Digital or
DTS decoder, be sure to select
"PCM". If "Bitstream" is selected,
starting DVD play may cause such a
high level of noise as to be harmful to
your ears and damage the speakers.
*2 When a dts decoder is connected,
please select "Bitstream" in "dts."
If "PCM" is selected, there will be
stereo sound.
When a Dolby Digital decoder is
connected, please select "Bitstream"
in "Dolby Digital."
If "PCM" is selected, there will be
stereo sound.
Recommended setting
LPCM Dolby
D T S
Digital
1
PCM*
P C M PCM*
Bitstream
P C M P C M
P C M Bitstream Bitstream
53
1
2
*