Connection To The Network - Fujitsu Lifebook A3040 User Manual

L i f e B o o k A S e r i e s N o t e b o o k - S e c t i o n F i v e
10. Click the Advanced tab
11. The Advanced tab allows for the configuration of
the options detailed in the table below..
Field Name Description
Power Save Options are Maximum, Normal, or
Mode Off
Network Type Options are AP (Infrastructure) or Ad
Hoc
802.11b Specifies the preamble setting in
Preamble 802.11b. The default setting is Short
and Long (Access Point mode),
which allows both short and long
headers in the 802.11b frames. Set
to Long Only to override allowing
short frames.
Transmit Options are 100%, 50%, 25%,
Power Level 12.5% or Lowest transmit power
(0mW)
Wireless Mode Specifies 5 GHz 54 Mbps, 5 GHz 108
Mbps, 2.4 GHz 11 Mbps, or 2.4 GHz
54 Mbps operation in an access
point network.
Wireless Mode Specifies 5GHz 54 Mbps, 5 GHz 108
when Starting Mbps, 2.4 GHz 11 Mbps, or 2.4 GHz
Ad Hoc 54 Mbps to start an Ad Hoc network
Network if no matching network name is
found after scanning all available
modes.
12. Click OK
13. If the profile you just created does not activate
immediately, click the Profile Management tab,
highlight the desired Profile, and click Activate.
14. Click [Close] if you want to close the Atheros Cli-
ent Utility.

CONNECTION TO THE NETWORK

This section explains connection to the network.
If there is an administrator of the network, contact the
network administrator for data settings.
Setting the network
Perform the "Setting TCP/IP" and "Confirming the
computer and work group names" operations required for
network connection.
58
Setting TCP/IP
To change the setting of the IP address,
you need to be logged in from Windows
as an administrator.
1. Click the [Start] button first and then [Control
Panel].
2. If the Control Panel is in Category view, switch to
Classic view by clicking "Switch to Classic View"
under Control Panel the left frame. (If you are
already in Classic view, "Switch to Category View"
will be displayed.)
3. Double-click [Network Connections]. A list of cur-
rently installed networks will be displayed.
4. Right-click [Wireless Network Connection] in the
list, and then click [Properties] in the menu dis-
played. The [Wireless Network Connection Prop-
erties] window will be displayed.
5. Click the [General] tab if it is not already selected.
6. Click [Internet Protocol (TCP/IP] and then click
[Properties]. The [Internet Protocol (TCP/IP)
Properties] window will be displayed.
7. Set the IP address as follows:
For ad hoc connection: Select [Use the following
■
IP address:] and then enter data for [IP address]
and [Subnet mask]. See page 64 for IP address
setting.
For access point (infrastructure) connection: If
■
your network uses DHCP, select [Obtain an IP
address automatically] and [Obtain DNS server
address automatically]. If your network uses
static IP addresses, consult with your network
administrator for the correct IP address settings.
8. Click the [OK] button. Processing will return to the
[Wireless Network Connection Properties] window.
9. Click the [OK] button.
10. Close the [Network Connection] window.
Following this operation, confirm the names of the
computer and the workgroup as follows.