Changing The Metering Mode - Canon 1100D Instruction Manual

E_3 Changing the Metering Mode _
Three methods (metering modes) to measure the subject's brightness
are provided. Normally, evaluative metering is recommended.
In Basic Zone modes, evaluative metering is set automatically.
Select [Metering mode].
Under the [_:] tab, select [Metering
mode], then press <_-_>.
Set t.emetering mode.
Select the desired metering mode,
then press <_-_>.
[_8"1 Evaluative metering
This is an all-around metering mode suited for
portraits and even backlit subjects. The camera
sets the exposure automatically to suit the
scene.
_3 Partial metering
Effective when the background is much brighter
than the subject due to backlighting, etc. The
gray area in the left figure is where the
brightness is metered to obtain the standard
exposure.
C-I Center=weighted average metering
The brightness is metered at the center and
then averaged for the entire scene. This
metering mode is for advanced users.
[_ With E83, the exposure setting will be locked when you press the shutter
button halfway and focus is achieved. With [0:3 and E3, the exposure setting
is set at the moment of exposure. (The exposure setting is not locked when
you press the shutter button halfway.)
100