Ventair Myka 2 Installation And Warranty Instructions

LOCATION
1) Precautions must be taken to avoid the back- ow of gases into the room from the open ue of gas or other fuel-
burning appliances.
2) The distance between the sides of the heater and the sides and any adjacent ceiling recessed heater shall not be
less than four times the minimum distance speci ed for the distance between the sides of the heater and any
building element adjacent to it.
3) The switches and other controls of the appliance should be installed so that they cannot be touched by a person
in the bath or shower.
Between the unit and thermal insulation please also keep 200mm clearance when installation.
POWER
Hz
MOUNTING
370mm x 202mm.
Please assemble the air outlet before insert the unit into the hole.
Air outlet assemble steps as below:
Insert the draft stopper on both
Connect the right and left side of slots. Please note that the Use screwdriver to take o the
smooth surface side of the
vents together screw which xed on body &
stopper should be toward the
outlet
round outlet.
3. Connect
swing clips to hold motor body in place( gure 1) then tighten screw to let
the clip clap onto the ceiling board( gure 2).
figure 1
Put the whole outlet along the Use the screw to x the
body slot body with outlet tightly
grille
clips
Rotate the
figure 2