Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Solem SMART-IS
- Page 1 THE CONNECTED IRRIGATION SMART-IS INSTALLATION GUIDE...
-
Page 2: App Download
INTRODUCTION SOLEM SMART-IS is a 230 V AC powered Wi-Fi and Bluetooth ® irrigation controller. Connected to the local weather forecasts it adapts the programming to weather changes. It can also follow your water consumption by connecting to a flow meter. -
Page 3: Create An Account
3. Follow the steps described on the app. Step 3 CONTROLLER SETUP Be sure that the place where you are wiring the SMART-IS is covered by a Wi-Fi connection. 1. Remove the SMART-IS bottom trap. 2. Plug the provided 230 /24 Vac power and put back the trap. -
Page 4: Sensor Settings
Step 4 SENSOR SETTINGS The SMART-IS has a - S + sensor input where you can plug in a rain sensor or a flow sensor. Once the sensor connected, it is necessary to set it up in the app. 1. Enter into the SMART-IS. - Page 5 High threshold (station’s flow alerts): maximum consumption in % of your established station’s flow rate. In case of limit exceeded, you will be instantly alerted (by email and smartphone and/or tablet notifications). Low threshold (station’s flow alerts): minimum consumption in % of your established station’s flow rate In case of not achieved goal, you will be alerted the next day at 7am (by email and smartphone and/or tablet notifications).
-
Page 6: Security Key
Waterbudget 110% When the automatic water budget is activated, the monthly water budget is desactivated. 1. Enter into the SMART-IS. 2. Tap on the p icon. 3. Tap on m Localization. 4. Authorize the app to enter to the localization service. - Page 7 Step 8 WIRING SMART-IS 1 - 6 SMART-IS 9 - 12 7 8 9 1 0 11 12 C 24 VAC - S + C P 1 2 3 4 5 6 Power Master valve Outputs SMART-IS 1 - 6...
- Page 8 Red LED blinking twice: the controller is no more time-syncronized, connect again to re-synchronize it. Red LED blinking 3 times: Wi-Fi signal lost (wrong Wi-Fi key or the SMART-IS installation is too far or the internet connection has been lost)
- Page 9 BEFORE SET UP OR USE THE SMART-IS. PLEASE RESPECT THESE PRECAUTIONARY MEASURES. The SMART-IS has to be installed indoor or in a sheltered place. Place your product in order to have the power outlet not far from the equipment. The socket is a sectioning device that has to be accessible all the time. Be sure that the power transformer has a protection against overintensifies and short-cuts, type 16A.
- Page 10 This symbol indicates that the power pack has a thermal protection of 130°C TECHNICAL FEATURES DIMENSIONS: Width 11 cm x Height 14,3 cm x Depth 4,2 cm (2/4/6) Width 16 cm x Height 14,3 cm x Depth 4,2 cm (9/12) POWER: Power supply INPUT: 230V ~ 50Hz / OUTPUT: 24V ~ 0.75A 50Hz USED FREQUENCY RANGE AND MAX TRANSMITTED POWER:...
Need help?
Do you have a question about the SMART-IS and is the answer not in the manual?
Questions and answers
I've just bought a Solem Smart-IS and when wiring it up I understand that -S+ is for the rain sensor C is for Common for the solenoids Is this correct and What is P for? Regards Harvey