MORDOMUS ENOWd Quick Start Manual

1. GENERAL FEATURES :
Reading points: 60 wireless input devices and 60 wireless
output devices.
Control: Via MD BUS e EnOcean®;
Applications: Interface between wireless devices and
EnOcean® Mordomus;
Installation: DIN Rail.
2. GENERAL SPECIFICATIONS :
Voltage: 12VDC;
Consumption: 70mA @ 12VDC;
Storage Temperature: -10ºC to 60ºC;
Operating Temperature: 10ºC to 50ºC;
Maximum Humidity: 80%, non-condensing;
Physical Specifications:
Dimensions: 105mm X 90mm X 70mm, DIN rail mounting (6
modules); Box Plastic, self-extinguishing UL-94 V0;
Level Protection: IP20, for indoor use.
3. COMPATIBILITY :
PCCWd Compatibility: Firmware 3.42 or higher.
Mordomus Software Compatibility: Mordomus Software
v2015.2 or higher;
4. SECURITY :
Before making any connections,
instructions carefully.
Never remove the plastic base from DIN rail.
5. CONNECTIONS :
Thickness of conductors:
Bus Circuit:
CAT6 Cable F/UTP shielded, twisted;
Power circuit:
Mono-wire or multi-wire at least 0.75 mm²
Manual: ENO-1642-EN
ENOWd – Gateway EnOcean ®
please read these
www.mordomus.com
Table of Connections:
Number Function
1 GND
2 MD BUS Inputs A
3 MD BUS Inputs B
4 GND
5 MD BUS Outputs A
6 MD BUS Outputs B
14 GND
15 +12VDC
16 GND
17 +12VDC
Connect the 12VDC:
The use of Mean-Well, DR60-12 or DR30-12 power supplies
is recommended.
Connect the Bus:
To connect the BUS, must be used a pair-Interlace CAT6
cable. For example, Green for A and Green/White for B,
The shield should be connected to GND.
If the module is the last module at Mordomus Bus, the
jumpers must be placed according to Fig 1 b) to close the
BUS chain. In other situations it should remain as in Fig 1 a).
Hardware: V1.31
Firmware: V1.3
Page 1/2