Honeywell Home SiXSIREN Installation And Setup Manual

Honeywell Home SiXSIREN Installation And Setup Manual

Wireless siren/strobe

Advertisement

Quick Links

This wireless siren/strobe is intended for use with Honeywell Home controls that support SiX™ series devices.

OPEN

Gently twist the top of the Siren counterclockwise and the mounting bracket clockwise to separate them.

MOUNTING

The SiXSIREN can be mounted on the wall or on the ceiling.
The rear tamper breakout [A] MUST be mounted to a stud, solid wood, or with a robust wall anchor.
After enrolling, verify adequate signal strength by conducting Go/No Go tests (see controller's instructions) with the device
in its intended mounting location. Adjust the device location and orientation as necessary.
Installation and Setup Guide
SiXSIREN
OPEN
SiXSIREN
Wireless Siren/Strobe

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SiXSIREN and is the answer not in the manual?

Questions and answers

John Holmes
March 16, 2025

How often do you have to replaced batteries? I lived here two years and this will be my third time I’ve replaced the batteries. I use lithium AA batteries. I haven’t armed the system at all. This is a Honeywell home wireless sixsiren.

2 comments:
Mr. Anderson
March 16, 2025

The Honeywell Home SiXSIREN uses four lithium AA batteries with an average battery life of five years.

This answer is automatically generated

John Holmes
March 16, 2025

@John Holmes what could cause my unit to use up the battery life in less than a year?

Summary of Contents for Honeywell Home SiXSIREN

  • Page 1 SiXSIREN Wireless Siren/Strobe Installation and Setup Guide This wireless siren/strobe is intended for use with Honeywell Home controls that support SiX™ series devices. SiXSIREN OPEN Gently twist the top of the Siren counterclockwise and the mounting bracket clockwise to separate them.
  • Page 2 See the Controller’s instructions for programming the device in the system. Refer to the LED and Sounder table for details of chime operation when the CHIME feature is enabled (factory default is enabled). DEFAULT SIXSIREN If the device is enrolled in a panel different than the intended panel, and...
  • Page 3 After 7 days, the sounder chirps once every 45 seconds until the batteries are replaced or die. See the Battery Replacement section. TEST THE SIXSIREN The SiXSIREN should be tested immediately after installation and weekly. Activate Test Mode remotely from the Controller (see Controller’s manual for details). The product must be tested at least once a year.
  • Page 4 For the latest warranty information, please go to: www.security.honeywellhome.com/warranty The Honeywell Home Trademark is used under license from Honeywell International Inc. This product is manufactured by Resideo Technologies, Inc and its affiliates. 2 Corporate Center Drive, Suite 100 P.O. Box 9040, Melville, NY 11747 ...

Table of Contents