Advertisement
(Fig. 9)
(Fig. 11)
Replace the lid (Fig. 10). Remember to ensure the pressure release plug is pulled all
the way out while closing, otherwise the air cannot escape. Squeeze the lid closed all the way
with the hissing of expelled air. Screw home the pressure release plug (Fig. 11). There is no
need to excessively tighten this plug. The seal is made by internal O-rings. The O-ring on the
underside of the plug is just to keep out dirt.
After replacing the lid, make a final visual inspection of the main O-ring for
contamination (Fig. 12).
(Fig. 10)
8
8/6/2006
Advertisement
