Advertisement
SWING-III
Remote Radio Sync and control system including HSS-High Sync Speed up to 1/8000sec(Canon)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Caution: Any changes or modifications to the equipment not expressly approved by the party responsible for compliance could void user's authority to operate the equipment. This appliance and its
antenna must not be co-located or operation in conjunction with any other antenna or transmitter. A minimum separation distance of 20 ㎝ must be maintained between the antenna and the person for
this appliance to satisfy the RF exposure requirements.
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Rime Lite SWING-III
Summary of Contents for Rime Lite SWING-III
- Page 1 SWING-III Remote Radio Sync and control system including HSS-High Sync Speed up to 1/8000sec(Canon) This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
- Page 2 SWING III will have Two execution modes. (HSS & NSS) If a user would like to use HSS, i-flash should be set ‘H-mode’. 1] HSS Mode ( High Sync Speed mode ) - This Mode supports High Sync Speed of Canon DSLR up to 1/8000sec.
- Page 3 4) Under HSS mode, all functions( Flash Mains power On/Off, Flash power Up/Down) is stopped for the smooth Operation with DSLR camera’s TTL. Swing III Transmitter is reacted only by DSLR’ TTL Driving signal. 5) HSS mode supports the shutter speed of Canon’s DSLR up to 1/8,000 sec. 2] NSS Mode (Normal Sync Speed mode) 1) Press HSS button for 2sec, HSS mode is canceled.
- Page 4 The changed operation way On Transmitter of SWING III Test Button Individual Channel(1~6) 1. Press one of flash individual buttons (1~6), the button LED lamp is turn it on and it shows Battery (2 x AAA size) that it is connected with the flash set the same Channel.
- Page 5 Operation Instruction for SWING-III-Receiver The LED indicator of Operation. Set the individual No (1~6) Group Selection (Group Channels) 1. Insert Receiver into the slot of back case as the picture above. 2. To set the group channel should be the same as Transmitter’s Group channel.
Need help?
Do you have a question about the SWING-III and is the answer not in the manual?
Questions and answers