Download Print this page

Sealey 39wireless User Manual page 2

Advertisement

the pairing is successful, LED will stop flashing.
LED :
7.
In unlocked state, the remote can control actuators normally and LED will on when you 
press any button. In locked state, LED will flash when you press any button which indicates 
the remote is locked. 
Child lock
8.
 
Press and hold the HEAD UP & HEAD DOWN and the LED will flash by 1Hz at the same time . 
After 5 times flash, the LED will turn off and the remote will enter into locked mode. 
Press the FOOT UP & FOOT DOWN , the LED will flash by 1Hz. After 5 times flash, the LED will 
turn off and the remote will enter into normal mode. 
 
Fcc warning
This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This equipment generates, uses and can 
radiate radio frequency energy and, if not installed and used in accordance with the instructions, 
may  cause  harmful  interference  to  radio  communications.  However,  there  is  no  guarantee  that 
interference  will  not  occur  in  a  particular  installation.  If  this  equipment  does  cause  harmful 
interference to radio or television reception, which can be determined by turning the equipment 
off  and  on,  the  user  is  encouraged  to  try  to  correct  the  interference  by  one  of  the  following 
measures: 
Reorient or relocate the receiving antenna. 
-
Increase the separation between the equipment and receiver. 
-
Connect the equipment into an outlet on a circuit different from that to which the 
-
receiver is connected. 
Consult the dealer or an experienced radio/TV technician for help. 
-
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
 
User Manuel
RF358C (39WIRELESS)
  2 / 2 
No:JLDK.18.01.29
Page 2 of 2
 

Advertisement

loading

This manual is also suitable for:

Rf358c