General Block Diagram - Panasonic KMF0609058CE Service Manual

6.2.

General Block Diagram

The following is an outline of each device IC on the digital board. (Refer to General Block Diagram (P.12).).
1. ASIC (IC501)
Composed mainly of an address decoder and a modem control.
Controls the general FAX operations.
Controls the operation panel I/F.
Controls the thermal head I/F and CIS I/F.
Performs the image processing.
CPU and Real time clock
Provides the reset pulse for each of the major ICs.
2. Flash ROM (IC506)
Contains all of the program instructions on the unit operations.
This memory is used mainly for the parameter working in the storage area.
3. Dynamic RAM (IC503)
This memory is used mainly for the parameter working in the storage area.
4. MODEM (IC505)
Performs the modulation and the demodulation for FAX communication.
5. Read Section
CIS image sensor to read transmitted documents.
6. Motor Driver (IC401)
Drives the transmission motor and the reception motor.
7. Thermal Head
Contains heat-emitting elements for dot matrix image printing.
8. Analogue Board
Composed of ITS circuit and NCU circuit.
9. Sensor Section
Composed of a cover open and film end switch, a document set switch, a document top switch, a paper top sensor and a
motor position switch.
10. Power Supply Board Switching Section
Supplies +6V and +24V to the unit.
11. Flash Memory (IC507) (KX-FP218 Only)
This memory is used for voice prompt and TAM.
11
KX-FP206CX/KX-FP218CX