LG LRFVS3006 Series Owner's Manual page 19

NOTE
• The number of wire harnesses may vary
depending on the model.
• Ground wire is only present on some models.
Assembling the Left Refrigerator
Door
CAUTION
• Install the left refrigerator door after the right
door is installed.
1
Make sure that the plastic sleeve is inserted in
the bottom of the door. Install the refrigerator
door onto the middle hinge.
2
Fit the hinge over the hinge lever latch
a
and slot it into place. Rotate the lever
clockwise and fasten the hinge.
3
Connect all the wire harnesses and the
ground wire.
4
Push the water supply lines into the hole on
the top case and pull them through the
backplate.
5
Hold the water supply connection and gently
push in the collet
supply lines as shown. Insert the tube at least
5/8 inch (15 mm) into the connector. Insert
the clip on the joint to fasten the tubes in
place.
NOTE
• Disassembling/Assembling the Water Lines
b
c
Collet
e
• Gently press the collet and insert the tube until
only one line shows on the tube.
INSTALLATION
to connect the water
d
Tube Insert line
f g h
19
Clip