Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Skyvue SECURITY ALARM DEVICE
- Page 1 OUTDOOR TELEVISIONS Digital Lock With Alarm...
- Page 2 ● The interval time between two detected vibration or removing the lock over three seconds activates alarm ● Cutting the cable or removing the battery cover activates alarm ● Wrong code entered 3 times activates alarm ● Alarm will sound up to 105dB ●...
- Page 3 After the battery installation, the unit will sound ‘Beep Beep’, and the LED will flash 1 to 2 sec. c). Make sure the screws are tightened securely prior to using. All Rights Reserved. 2020 SkyVue Mounting to Post or Cart (40”, 46”, & 52”)
- Page 4 LOCK And UNLOCK LOCK: a). LOCK:Press [lock/unlock] button once and do not push the lock bar. The unit will sound three beeps, LED will flash every 3 seconds, then the unit is in the LOCK mode. b). UNLOCK: In the lock mode, enter your 4 digits password then press [lock/unlock] button.
- Page 5 Anti-Theft Anchor Point located in the back lower corner of your television as shown below. NOTE: This is shown with a post mount however we use the same tilt bracket for multiple installations including the ceiling mount. All Rights Reserved. 2020 SkyVue...
- Page 6 Please take care of all of your property. Congratulations you have succesfully installed your SkyVue Security Alarm. If you have questions feel free to contact our technical support team (877) 475-9883 ecurIty...
- Page 7 Trouble Reasons Solution 1. Battery cover is loose. 1. Tighten screws securely in the cover. No alarm when triggered 2. Make sure the cable is plugged in lock hole and deep enough . The cable is not pushed in far enough. in the locked mode 3.
Need help?
Do you have a question about the SECURITY ALARM DEVICE and is the answer not in the manual?
Questions and answers