Advertisement
Product Name:
Thank you for purchasing this product. This product has been manufactured with the highest standards of
safety and quality.
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Unpack all parts from Styrofoam and bubble wrap inside the carton to ensure there are no missing or damaged
parts. If any parts are missing or damaged, do not attempt to assemble or use the product.
CARTON CONTENTS:
Description
Fountain
Pump
Compatible Pumps for this fountain:
Pump Model No.
JR600
JB650
YH560
Tools required for assembly: No tools required for assembly.
Assembly Instructions:
1. Unpack the contents of the box and check to make sure that all items are accounted for and in good
condition.
2. Select a flat, level surface for the assembly and final location of your fountain.
3. From the opening at the back of the fountain base, insert the water supply tube into the pump outlet. Place
the pump upright in the basin and draw the pump power cord out of the fountain back. (①)
4. Add clean water into the basin. The water level should be approximately 30mm lower than the edge of the
basin. (②)
5. Connect the pump power cord to a ground fault circuit interrupter (GFCI) outlet and the product will begin
to function as intended. (③)
6. To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing
after the initial setup of your fountain. It is highly recommended that this fountain be placed in an area
where it cannot be damaged.
7. Do not leave your fountain running for extended periods of time when no one is present to observe the
performance.
8. Check the area around your fountain on a regular basis to ensure that there is no leakage.
9. Please refresh the fountain with water each week to ensure it in good condition.
10. Do not add any harmful chemicals to the water as it may alter the paint finish.
Instruction Manual
SAVE THESE INSTRUCTIONS–This manual contains
important safety and operating instructions for power units.
Resin Cascading Rock Outdoor Fountain
Quantity
1
1
Advertisement
Table of Contents
Related Manuals for Winsome house JB650
Summary of Contents for Winsome house JB650
- Page 1 Pump Compatible Pumps for this fountain: Pump Model No. JR600 JB650 YH560 Tools required for assembly: No tools required for assembly. Assembly Instructions: 1. Unpack the contents of the box and check to make sure that all items are accounted for and in good condition.
- Page 2 Instruction Manual SAVE THESE INSTRUCTIONS–This manual contains important safety and operating instructions for power units. Product Name: Resin Cascading Rock Outdoor Fountain Note: The above diagram is for illustrative purposes only.
- Page 3 Instruction Manual SAVE THESE INSTRUCTIONS–This manual contains important safety and operating instructions for power units. Product Name: Resin Cascading Rock Outdoor Fountain MAINTENANCE OF YOUR PUMP: Keep the water clean – clean water will prolong the useful life of your pump. •...
- Page 4 Instruction Manual SAVE THESE INSTRUCTIONS–This manual contains important safety and operating instructions for power units. Product Name: Resin Cascading Rock Outdoor Fountain • Check the water level regularly to ensure the pump is completely submerged during operation. The pump should be fully submerged during operation. Do not add water while operating the product. Always disconnect the pump from the power source before adding water.
Need help?
Do you have a question about the JB650 and is the answer not in the manual?
Questions and answers