Sercomm SW-DWS02N Installation Manual

SW-DWS02N Door/Window Sensor Installation Guide

Introduction

Z-Wave Door/Window sensors are designed to secure the perimeter of the residential premise, and provide the
ability to add various automation services. The Z-Wave Door/Window sensor, which consists of a magnet that
attaches to a door or window, will communicate door events to the home security system. When the magnet is
moved away from the sensor, a signal will be sent to the control panel that communicates the changed state to the
security system. Signals can also be used to activate a chime or convenience lighting based on system settings.

Specification

Frequency
Battery Type
Operating Temperature
Storage Temperature
Operating Air Range
Dimension

Add (Inclusion) Sensor

For Adding in (Inclusion) a network: Put the Z-Wave Interface Controller into "Add (Inclusion)" mode, and
following its instruction to add SW-DWS02N to your controller. This Door/Window sensor needs to be included
before installation.
1. Pull the exposed plastic tab from the sensor. (Figure 1)
2. The Green LED indicator will be lit for one second to indicate a successful booting.
3. It will blink one time every second while scanning the network (Figure 2).
4. If network is not found after 30 seconds, the sensor will go into sleep mode. To wake the sensor again, you
need to use magnet or tamper (Figure 3) to trigger a Adding (Inclusion) process, and then sensor will repeat
steps from 3 to 4.
CR2 Battery
922.5 / 923.9 / 926.3 MHz
CR2 Battery 1 PCS
0 C to 50 C (32°F - 122°F)
-20 C to 60 C (-4°F - 140°F)
Up to 148 feet line of sight
Device: 67 mm x 19 mm x 20 mm (2.63" x 0.74" x 0.78")
Magnet: 45 mm x 8 mm x 15 mm (1.77" x 0.31" x 0.59")
Green LED Indictor
Tamper Switch
Figure 1
Figure 2
Figure 3