Safety Solutions SECURE SVA-2Y Quick Start Manual

FALL PREVENTION WITHOUT THE NOISE!
INSTRUCTIONS
The feature rich Secure Voice Alarm was
®
designed to provide the option of in room silence
while providing maximum fall management
benefits. The alarm is to be used with Secure
Bed or Chair Sensor Pads or the Secure
Belt as part of a total fall management program.
If using with the Secure Seat Belt please refer
®
to your seat belt instructions. The following
instructions cover the use of this product
with Secure Bed or Chair Sensor Pads.
®
This product is not a restraint. It will not
prevent a resident from getting out of their
bed or chair.
1. Please refer to Illustration A below for the
following steps:
a. Open the sliding tamper resistant cover on
side of alarm with a Phillips screw driver.
b. If using a nurse call cable determine if you
want to silence the alarm in the resident's
room. If you DO NOT want the alarm or
voice to activate in the resident's room
when using the nurse call feature, slide
"Off/On" switch to the "Off" position. If you
DO want the alarm or voice to activate in
the room and at the nurse's station slide
the "Off/On" switch to the "On" position.
PLEASE NOTE: IF YOU DECIDE TO
SILENCE THE ALARM OR VOICE IN
THE RESIDENT'S ROOM WHEN USING
THE NURSE CALL SYSTEM THE "Off/
Personal Safety Corporation • Hiawatha, Iowa 52233 • 800.373.2873 • www.SecureSafetySolutions.com
VOICE OR DUAL TONE ALARM
WITH HOLDER & NURSE CALL FEATURE
(SVA-2Y) INCLUDES TAMPER-PROOF
"IN-ROOM SOUND" SWITCH TO SILENCE
VOICE OR ALARM IN RESIDENT'S ROOM
PRODUCT FUNCTIONS WITH SECURE
SENSOR PADS AND SECURE
On" SWITCH SHOULD BE IN THE "OFF"
POSITION. IF YOU WANT THE ALARM
TO SOUND IN THE RESIDENT'S ROOM
THE NEXT TIME USED YOU MUST MOVE
THE "Off/On" SWITCH TO THE "ON"
POSITION.
c. Insert nurse call plug into opening marked
"Nurse Call." Insert pin of bed or chair
sensor pad into opening marked "Sensor
®
Pad." CAUTION! ALWAYS remove
Seat
®
sensor pad pin from alarm by pulling
straight up on the white "PULL" tab.
DO NOT attempt to remove pin any
other way or you may damage pin
and void warranty.
d. Carefully thread the nurse call cord and/
or pad cord through the slot opening at the
bottom of the alarm.
e. Close sliding tamper-resistant cover and
tighten screw with Phillips screwdriver to
prevent tampering.
2. Please refer to Illustration B below for the
following steps:
Illustration A
a. Open battery cover on back of alarm by
removing tamper-resistant screw and
sliding the battery cover in the direction of
the arrow with your thumbs. The battery
cover will open and stay attached to
SEAT BELT
®
the alarm. Install three "AAA" batteries
"included" into battery compartment per
the "+/-" diagrams on the bottom of the
battery holder. The alarm will beep twice.
b. The alarm also has an AC/DC Adapter
plug-in option on the side of the alarm.
Please refer to Illustration A. If at all
possible it is recommended that you use
an AC/DC Adapter along with the batteries
to prolong the life of the batteries. (See our
order form to order our Secure
DC Adapter - Model # ACDC-1.)
c. Decide if you want the alarm to sound with
a recorded voice or an alarm tone. If you
decide on an alarm tone move the "Voice/
Tone" switch to the right under "Tone"
where you have two choices as follows:
1. If you would like to have a continuous
alarm tone move the switch marked
"Tone 1/Tone 2" to the left so that it is
positioned under "Tone 1." To hear this
tone simply press and hold down the
"Test/Reset" button on the front of the
alarm.
2. If you would like to have a pulsating
alarm tone move the "Tone 1/Tone
2" switch to the right so that it is
positioned under "Tone 2." To hear this
sound simply press and hold down the
"Test/Reset" button on the front of the
alarm.
If you do not want to record a voice
message, skip to Point 4 below.
d. If you want the alarm to sound with a
recorded voice message move the "Voice/
Tone" switch to the left so that it is
Illustration B
positioned under "Voice" and follow the
instructions in Point 3 below.
3. TO RECORD A VOICE MESSAGE
a. Decide what you would like the message
to say and the person who will record
the message. Your message can be up
®
BED OR CHAIR
®
6-Volt AC/
®
Continued
Revised: 07/26/17