Table of Contents
Advertisement
M
Signal setting
Y ou can change the following settings:
S i g n a l s e t t i n g
The spin speed that is used for
■
spinning your laundry before it is
dried,
The volume of the audible signal at
■
the end of the programme,
The volume of the audible button
■
signals,
The current rating for your dryer's
■
fuse (10 A or 13 A).
The values for the energy
Note:
label are determined using a circuit
breaker/fuse rating of 13 A. If the
circuit breaker/fuse rating is
changed to 10 A, the drying time
and energy consumption will be
higher. You can find details on this in
the consumption values table.
~ Page 36
You will need to activate the setting
mode in order to change these settings.
Activating setting mode
Switch the dryer on.
1.
Select the Cottons programme in
2.
position 1 and wait 5 seconds.
Setting mode is now activated. The
symbols go out on the display panel
and the programme duration is
displayed.
Press and hold the Start button and,
1.
at the same time, turn the
programme selector clockwise to
position 2.
The spin speed is shown on the
2.
display.
Press the "Ready in" time button or
3.
the drying time button to change the
spin speed.
Turn the programme selector
4.
clockwise to position 3.
The volume of the audible signal at
5.
the end of the programme is shown
on the display.
1 = quiet, 2 = medium,
3 = loud, 4 = very loud
Press the "Ready in" time button or
6.
the drying time button to change the
volume.
Signal setting
en
29
Advertisement
Table of Contents
