Care And Maintenance - Cuisinart COH-100 Manual

CARE AND MAINTENANCE

Cleaning
• Abrasive cleaners will damage this product.
• Never use oven cleaner to clean any part of fire table.
• Do not clean any fire table part in a self-cleaning oven. The extreme heat will damage the finish.
• More frequent cleaning may be required as necessary. It is imperative that control compartment, burners and circulating air
passageways of the fire table be kept clean.
• Spiders and insects can create a dangerous condition that may damage fire table or make it unsafe. Keep burner area clean of
all spiders, webs or insects. Clean burner holes by using a heavy-duty pipe cleaner. Compressed air may help clear away smaller
particles.
• Carbon deposits may create a fire hazard.
• Do not clean fire table with combustible or corrosive cleaners. Use warm, soapy water.
• This fire table should be thoroughly cleaned on a regular basis.
• Wipe surfaces clean with mild dish detergent or baking soda. Rinse clean with water.
• For stubborn surfaces use a citrus-based degreaser and a nylon scrubbing brush.
• After the burner and rocks are completely cooled down, use a soft brush to get rid of the mild stains, loose dirt and soil.
Wipe with a soft cloth.
• Stubborn stains, discoloration and possible rust pitting can occur from exposure to harsh outdoor conditions.
• Be careful not to let any powder or solvent come in contact with painted or plastic components as damage may occur.
Note: While cleaning the unit, be sure to keep the area around the burner dry at all times. Do not submerge the control valve
assembly. If the gas control is submerged in water, do NOT use it. It must be replaced.
Maintenance
• Keep exterior surfaces clean.
• Store the fire table in a cool dry place away from direct sunlight.
• Make sure to disconnect the propane cylinder and the fire table is turned off before changing the battery. Please refer to the
process of inserting battery.
• The propane cylinder must be disconnected and stored outdoors before the fire table can be stored indoors.
• Use Manufacturer approved or supplied replacement parts and accessories only. Otherwise may void the warranty of this
product and result in a hazardous condition.
• Please contact the Manufacturer for information regarding replacement, valves, ignitor, regulator etc.
• Air flow must be unobstructed. Keep controls, burner and circulating air passageways clean.
Signs of possible blockage include:
Gas odor with extreme yellow tipping of flame.
This unit does NOT reach the desired temperature.
This unit glow is excessively uneven.
This unit makes popping noises.
Note: In a salt-air environment (such as near an ocean) corrosion occurs more quickly than normal. Frequently check for
corroded areas and repair them promptly.
Inspecting
This outdoor fire table must be inspected regularly to insure that the product is safe to use and to extend product life.
WARNING: DO NOT inspect this gas fire table until the fire is completely out.
• Check the burner to make sure it is securely in place.
• Check the Venturi tube to make sure it is clear and free of insects, spider nests and other debris.
• Check all gas connections for leaks.
• Check ignition system to insure proper sparking.
• Check components for any signs of damage, rust or excessive wear.
• If damage to any component is detected, DO NOT operate until the proper repairs have been made.
Storage
CAUTION: Wait until the fire is out and the rocks are cool down before covering.
Between uses or during periods of extended inactivity:
• Turn control knob to "OFF".
• Disconnect LP cylinder and move to a secure, well-location outdoors.
• Carefully remove rock filler and store components flat to protect them from breakage.
• Store in a cool, dry location away from children and pets.
• ALWAYS cover your outdoor fire table when not in use with the PVC cover( not included).
• Note: Never leave LP gas tank exposed to direct sunlight or excessive heat.
• If desired, use cover (sold separately) to protect the fire table and help prevent buildup in air passages.
8 1