Uniflame GBT1102W-C Owner's Manual page 6

Assembly Instructions (continued)
9
Attach Lid
10
Fold Legs
Note: Wire legs must lock lid before moving.
Unfold Legs
Note: Always open legs completely and secure in place before lighting.
Outdoor LP Gas Barbecue Grill Model No. GBT1102W-C
Operating Instructions
This grill is designed to operate with a one pound
7.75" or 10.6" high disposable / 16.4 oz. or 14.1 oz.
propane gas tank (DOT 39 Cylinder) (Figure 1).
DO NOT ATTEMPT TO REFILL ANY ONE POUND (16.4
oz. or 14.1 oz.) PROPANE GAS TANKS!
Connect LP Gas Tank
Only cylinders marked "propane" may be used.
Note: Some 1-lb cylinders may form frost when near
empty.
1. Make sure the regulator/control knob is in the
"OFF " position (Figure 2).
2. Lubricate the threads of the regulator/control knob
with petroleum jelly. Line up threads on LP gas tank
with regulator/control knob.
3. Insert and rotate LP gas tank clockwise until they fit
snugly together. HAND TIGHTEN ONLY. Be careful not
to cross threads when screwing in canister
(Figure 3).
4. Test for leaks, see "Checking for Leaks" section.
Disconnect LP Gas Tank
1. Turn the regulator/control knob to the "OFF "
position (Figure 2).
2. Rotate LP gas tank counterclockwise until it is loose
(Figure 4).
3. Store the LP gas tank in a proper location, per LP
gas tank instructions.
Checking for Leaks
Burner Connections
1. Make sure the regulator/control knob is securely
fastened to the burner.
Note: The brass nut should be 1/4 to 1/2 turn past
tight. The regulator will rotate 360º even when the
brass nut is tightened.
If your unit was assembled for you, visually check
the connection between the burner and regulator/
control knob (Figure 4).
WARNING: Failure to inspect this
connection or follow these instructions
could cause a fire or an explosion
which can cause death, serious bodily
injury or damage to property.
2. If the burner and regulator/control knob do not fit
properly or if you have any questions please contact
1.800.762.1142 for assistance.
Tank/Gas Line Connection
1. Make 2-3 oz. of leak solution by mixing one part
liquid dishwashing soap with three parts water.
2. Make sure regulator/control knob is in the "OFF "
position (Figure 2).
3. Spoon several drops of solution, or use squirt bottle,
at all "X" locations (Figure 5).
a. If any bubbles appear remove the LP gas tank and
reconnect, making sure the connection is secure.
b. If you continue to see bubbles after several attempts, remove the LP gas tank per
"Disconnect LP Gas Tank" instructions, and contact 1.800.762.1142 for assistance.
c. If no bubbles appear after one minute, wipe away solution and proceed.
First Use
1. Make sure all labels, packaging and protective films have been removed from the grill.
2. Remove manufacturing oils before cooking on this grill for the first time by operating the
grill for at least 15 minutes on (HIGH) with the lid closed. This will "heat clean" the internal
parts and dissipate odors.
Figure 1
1 lb
1 lb
453 g
453 g
3.875 in. / 9,8 cm
2.9 in. / 7,4 cm
Figure 2
Figure 3
Figure 4
Figure 5
X
X