Advertisement
Genuine KPX6v1 Tri-Tran Wireless Keypad
Storing your PIN Code
Note: There is a timeout of approximately 5 seconds after the last button is
pressed.
a.
Enter 1111 followed by the hash (#) key.
b.
Press and hold the hash (#) key again. The keypad will beep for
approximately 5 seconds. Once the beeping stops, release the hash (#) key.
Enter the new pin code followed by the hash (#) key. Re-enter the new pin
code followed by the hash (#) key to confirm. A short string of beeps will be
produced to confirm the acceptance of the new pin code.
c.
Test operation using the new code. Enter the new code followed by the
hash (#) key. Press and hold any button from 1-8 and you should hear a
continuous string of beeps.
If you lose or forget a code, you will need to return the Keypad to B&D
Note:
Doors for reprogramming. A charge will apply for this service.
ABN 27 106 103 315
www.aggdoors.com.au
enquiries@aggdoors.com.au
(03) 8789 1342
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for B&D Genuine Tri-Tran KPX6v1
Summary of Contents for B&D Genuine Tri-Tran KPX6v1
- Page 1 ABN 27 106 103 315 www.aggdoors.com.au enquiries@aggdoors.com.au (03) 8789 1342 Genuine KPX6v1 Tri-Tran Wireless Keypad Storing your PIN Code Note: There is a timeout of approximately 5 seconds after the last button is pressed. Enter 1111 followed by the hash (#) key. Press and hold the hash (#) key again.
- Page 2 Coding the Wireless Keypad into the Opener a. Press the CODE SET button and release. The CODE SET LED will illuminate to indicate that the opener is in Code Learn mode. If a valid code is not stored within 15 seconds, the opener will exit Code Learn. b.
Need help?
Do you have a question about the Genuine Tri-Tran KPX6v1 and is the answer not in the manual?
Questions and answers