Advertisement
Table of Contents
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Mac Afric RM 18
Summary of Contents for Mac Afric RM 18
- Page 1 ROTARY MACHINE MODEL RM 18 Assembly & Operating Instructions...
- Page 2 DESCRIPTION Rotary machine is hand operated and will form sheet metal up to 18 Gauge thickness mild steel (or equivalent). The Rotary machine is constructed of cast iron and steel ensuring minimum deflection of the workpiece during forming operations. Six die sets are included, allowing the following operations to be per-formed: wiring, edging, ogee bead, single bead, and elbow edging.
-
Page 3: Installation
that may affect proper operation. Any part that is damaged should be properly repaired or replaced by an authorized service center unless otherwise indicated elsewhere in the instruction manual. 10. REPLACEMENT PARTS AND ACCESSORIES. When servicing, use only identical replacement parts. Only use accessories intended for use with this tool. 11.DO NOT OPERATE TOOL IF UNDER THE INFLUENCE OF ALCOHOL OR DRUGS. -
Page 4: Operation
OPERATION 1. Select the die set required for the operation to be performed. 2. Place spacers’ dies and retaining nuts onto the driving and driven shafts Tighten the retaining nuts with wrench provided. 3. Adjust the position of the upper die according to thickness of the workpiece by using the adjusting handle. -
Page 5: Parts List
PARTS LIST Part Description Part Description Head screw M10 Copper bushing Washer Gear Hex screw Square screw Concave wheel Handle Screw Handle lever Concave wheel II Washer Cam II Head screw M12 Cam III Hex screw m6 Concave wheel III Roll dies I-1 Bushing Roll dies I-2... - Page 6 Note: This manual is only for your reference. Owing to the continuous improvement of the machine, changes may be made at any time without obligation on notice.
Need help?
Do you have a question about the RM 18 and is the answer not in the manual?
Questions and answers