Advertisement
4. STORAGE
4.1.
If there is a risk of frost, dismantle the pump and accessories, clean and store them in a place protected from frost.
5. TROUBLESHOOTING
Fault
Pump does not run.
Pump runs but does not
pump.
Delivery rate low
Pump runs very loudly.
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed
of in an environmentally protective way. Contact your local solid waste authority for recycling information.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack Sealey Limited
Cause
No mains voltage?
Motor overheats due to:
- liquid temperature too high
- pump blocked by foreign bodies
Residual current circuit breaker (RCCB)
triggered.
Motor defective.
Suction openings blocked.
Pump draws in air.
Pump blocked by foreign bodies.
Delivery height too great.
Pressure line diameter too small.
Pressure line blocked.
Suction openings blocked.
Pressure line kinked.
Pressure line leaks.
Pump draws in air.
Dispose of this product at the end of its working life in compliance with the EU Directive on
Sole UK Distributor, Sealey Group.
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk.
IP32 7AR
Original Language Version
Solution
Check cables, plug, socket and fuse.
Eliminate the cause of the overheating of the liquid (max.
temperature of liquid able to be pumped is 35°C.
Activate RCCB.
Contact qualified electrician if RCCB triggers again.
Contact Sealey service.
Rectify blockage.
Keep the pump at an angle while submerging.
Switch the pump on and off several times in order to expel
air.
Clean the pump suction area.
Comply with specifications (8m max. head)
Use pressure line with larger diameter.
Rectify blockage.
Clean suction opening.
Straighten pressure line.
Seal pressure line, tighten threaded connections
Ensure there is sufficient liquid present.
Keep the pump at an angle while submerging.
Environmental Protection
WEEE Regulations
01284 757500
01284 703534
www.sealey.co.uk
Web
sales@sealey.co.uk
WPD415| Issue 1 15/12/15
Advertisement
