Bosch BC1836 Operating/Safety Instructions Manual page 5

BM 2610033301 10-13_BC630 10/11/13 10:52 AM Page 5
Plug charger cord into your standard power
outlet.
With no battery pack inserted, the charger's
green indicator light will go ON. This indicates
the charger is receiving power and the charger
is ready for operation.
When you insert the battery pack into the
charger. The charger's green indicator light will
begin to "BLINK". This indicates that the battery
is receiving a fast charge (Fig. 1).
When the indicator light stops "BLINKING" (and
becomes a steady green light) fast charging is
complete. The battery pack is fully charged and
can be removed from the charger.
The battery pack may be used even though the
light may still be blinking. The light may require
more time to stop blinking depending on
temperature.
The purpose of the green light is to indicate that
the battery pack is fast-charging. It does not
indicate the exact point of full charge. The light
will stop blinking in less time if the battery pack
was not completely discharged.
When you begin the charging process of the
battery pack, a steady red light could also
mean the battery pack is too hot or too cold.
Fast charging is only possible when the
temperature range of the battery pack is
between 32˚F (0˚C) and 113˚F (45˚C). When
needed, the internal fan of the charger will turn
on to aid the charging process and speed.
As soon as the battery pack reaches the
correct temperature range, the battery charger
will automatically switch to fast charging.
W RNING
Battery packs
BAT610G through BAT625
Voltage rating 18V
For most up to date battery compatibility, please refer to www.boschtools.com
Charging Battery Pack (model BC630)
This charger will only charge the following batteries:
"SAVe THeSe INSTRUCTIoNS"
-
5-
If the red indicator light is "BLINKING", the
battery pack cannot accept a charge.
• Check to make sure the battery pack is
inserted into the charger properly.
• Clean the contacts of the charger or battery
pack (e. g. by inserting and removing the
battery several times) or replace the battery
pack, as required.
When the battery pack is fully charged, unplug
the charger (unless you're charging another
battery pack) and slip the battery pack back
into the tool.
FIG. 1
RED LIGHT GREEN LIGHT
Charger (model BC630)
Voltage rating 120 V
B TTERY
P CK
CH RGER
60 Hz