Download Print this page

Bogen SPS2466 Installation

24v power supply

24V Power Supply

Model SPS2466

Installation

1. Place the holster against the wall and, using the screws provided,

attach the power supply holster to the wall.

2. Insert the power supply into the holster.

3. Connect the DC Plug-In Cable and wire tie it to the holster.

4. Connect the AC Line Cord and wire tie it to the side of the holster

opposite the DC Plug-In Cable.

NOTE: Current draws of less than

300mA may cause a low level

audible noise on the DC output.

Specifications subject to change without notice.

Mount

Power

Screws

LED

54-2211-01C

1301

Table of Contents

Do you have a question about the SPS2466 and is the answer not in the manual?

Page 1 4. Connect the AC Line Cord and wire tie it to the side of the holster opposite the DC Plug-In Cable. Mount Power Screws NOTE: Current draws of less than 300mA may cause a low level audible noise on the DC output. Specifications subject to change without notice. © 2012 Bogen Communications, Inc. 54-2211-01C 1301...
Page 2 Limited Warranty; Exclusion of Certain Damages The Bogen SPS2466 24V Power Supply is warranted to be free from defects in material and workmanship for two (2) years from the date of sale to the original purchaser. Any part of the product covered by this warranty that, with normal installation and use, becomes defective (as confirmed by Bogen upon inspection) during the applicable warranty period, will be repaired or replaced by Bogen, at Bogen’s option, provided the product is shipped...