Advertisement
5. Battery Status Check - Short-press
LED indicator lights will show an approximate battery percentage remaining (25-50-75-
100%), and speaker will announce battery "Full/Medium/Low"
EXTRA DETAILS
•
Automatic Power-Off - If there is no sound coming through the speaker for
approximately 45 minutes, the speaker will automatically power-off to save battery
•
Grouped Speakers - Multi-Link - Once speakers have been previously paired and
connected via Multi-Link, they will automatically connect again to their previous setting
upon their next power-on.
Important: You must power on all SUB speakers within 1-minute of MASTER
o
speaker powering on in order to resume Multi-Link. After 1-minute, the MASTER
speaker stops searching for new SUB speakers, and you will need to repeat
Multi-Link setup as described above.
•
Tech Specs
Power Output: 10 Watts
o
Play Time Estimate: Up-to 12 hours
o
Bluetooth 5.0, A2DP Audio protocol
o
Connection Distance: 80ft to phone
o
Supports Two-Phone Connection
o
Supports up to 100 Multi-link enabled speakers
o
If All Else Fails, Get in Touch
support@tech-life.com
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions☹1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
Any changes or modifications not expressly approved by the party responsible for compliance could void the
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable
| facebook.com/TechLifeOfficial | instagram.com/TechLifeOfficial
www.tech-life.com
FCC Information
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Consult the dealer or an experienced radio/TV technician for help.
including interference that may cause undesired operation.
user's authority to operate the equipment.
exposure condition without restriction.
FCC ID: 2ARTG TL10BM-01
button to check the current battery status. The
Advertisement
