Table of Contents
Advertisement
6. Remove the four Phillips PM2.0x4.0 screws 1 that secure the TouchPad board to the base enclosure. Then
remove the TouchPad board and bracket 2.
7. Remove the two Phillips PM2.0x4.0 screws 1 that secure the switch actuator to the TouchPad board bracket,
and then remove the actuator 2.
✎
The TouchPad is glued to the top cover and is included with the top cover spare part.
Reverse this procedure to install the TouchPad on/off button board and board bracket.
Removal and replacement procedures
4–33
Advertisement
Table of Contents
