Table of Contents
Advertisement
Quick Links
A Quick Start Guide to Setting up the Solar Power Supply
www.indsci.com
for the Radius
SUPPLIES YOU WILL NEED
For unpacking and assembly
•
Utility knife
•
Compass or compass app on smartphone
•
Level (optional)
•
Mallet for driving stakes (optional)
®
®
BZ1 and RGX
For battery installation or removal
•
Flathead screwdriver
•
Adjustable wrench
•
Socket set with 6" extension
•
Volt meter
Gateway
Advertisement
Table of Contents
Related Manuals for Industrial Scientific Solar Power Supply
Summary of Contents for Industrial Scientific Solar Power Supply
- Page 1 A Quick Start Guide to Setting up the Solar Power Supply ® ® for the Radius BZ1 and RGX Gateway SUPPLIES YOU WILL NEED For unpacking and assembly For battery installation or removal • • Utility knife Flathead screwdriver •...
- Page 2 BZ1 and RGX Gateway STEP 1: SITE SELECTION Before setting up the Solar Power Supply (SPS), carefully select the site. Select an open, outdoor location with abundant sunshine. Avoid obstacles (e.g. trees, buildings, etc.) that may block the sun and...
- Page 3 WARNING: When the Solar Power Supply (SPS) is located in a hazardous-classified area NEVER open the SPS enclosure to install or remove, or to connect or disconnect the SPS battery.
- Page 4 If it appears that the SPS or a device powered by the SPS is not working correctly, contact Industrial Scientific. IMPORTANT: Only clean using a damp cloth. The Magnet Mount Kit for use with the RGX Gateway and individual kit items can cause injury. To avoid injury, Industrial Scientific recommends the following.
Need help?
Do you have a question about the Solar Power Supply and is the answer not in the manual?
Questions and answers