Download  Print this page

Connecting The Dishwasher; Water Connection; Permitted Water Pressure; Connect The Inlet Hose - AEG FAVORIT 3A User Instructions

Aeg dishwasher user manual.
Hide thumbs

Advertisement

Installation and Connection Instructions

Connecting the Dishwasher

Water Connection

The dishwasher is fitted with safety devices that prevent the wash
water returning into the drinking water system and comply with the
applicable plumbing regulations.
• The dishwasher can be connected to cold and hot water supplies up
to max. 60 °C.
• The dishwasher must not be connected to open hot water appliances
or instantaneous water heaters.

Permitted water pressure

Lowest permitted water pressure:
1 bar (=10 N/cm
Highest permitted water pressure:
10 bar (=100 N/cm

Connect the inlet hose

The water inlet hose must not be kinked, crushed or entangled when it
1
is being connected up.
Connect the threaded hose fitting (ISO 228-1:2000) on the water inlet
0
hose to a tap with an external thread (¾ inch). Tighten the threaded
hose fitting hand tight only.
• In order that access to the tap in the kitchen is not limited by the use
3
of the dishwasher, we recommend the installation of an additional
tap, or fitting a two way adapter to the existing tap.
• If you need a longer water inlet hose than that supplied, VDE
approved complete hose sets are to be used. These are available from
your local Service Force Centre.
34
2
=100 kPa)
2
=1 MPa)
Consult your installer if the water pres-
sure is less than 1 bar.
In the case of a water pressure greater
than 10 bar, a pressure reduction valve
must be used (available from your
dealer).

Advertisement

Table of Contents

   Also See for AEG FAVORIT 3A

Comments to this Manuals

Symbols: 0
Latest comments: