Table of Contents
Advertisement
when attaching the radio to your belt, etc., to ensure FCC/IC RF exposure
compliance requirements are not exceeded. To provide the recipients of your
transmission the best sound quality, hold the microphone at least 2 inches (5 cm)
from your mouth, and slightly off to one side.
The information listed above provides the user with the information needed to make
him or her aware of RF exposure, and what to do to assure that this radio operates
within the FCC/IC RF exposure limits of this radio.
Electromagnetic Interference/Compatibility
WALT radio generates RF energy that can possibly
During transmissions, your D
E
cause interference with other devices or systems. To avoid such interference, turn off
the radio in areas where signs are posted to do so. DO NOT operate the transmitter in
areas that are sensitive to electromagnetic radiation such as hospitals, aircraft, and
blasting sites.
IMPORTANT NOTICE:
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation
Changes or modi cations not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
A-7
This radio is designed for and classi ed as "Occupational/Controlled Use Only",
meaning it must be used only during the course of employment by individuals aware
of the hazards, and the ways to minimize such hazards; NOT intended for use in an
General population/uncontrolled environment
– DO NOT operate the radio without a proper antenna attached, as this may damage
the radio and may also cause you to exceed RF exposure limits. A proper antenna
is the antenna supplied with this radio by the manufacturer or an antenna
speci cally authorized by the manufacturer for use with this radio.
– DO NOT transmit for more than 50% of total radio use time, more than 50% of the
time can cause RF exposure compliance requirements to be exceeded.
– This transmitter may operate with the antenna(s) documented in this ling in
Push-to-Talk and body-worn con gurations. RF exposure compliance is limited to
the speci c belt-clip and accessory con gurations as documented in this ling and
the separation distance between user and the device or its antenna shall be at
least 2.5 cm.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada's licence-exempt RSS(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes :
(1) l'appareil ne doit pas produire de brouillage;
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre le fonctionnement.
Cette radio est conçue et classée comme «Utilisation professionnelle / contrôlée
uniquement», ce qui signi e qu'elle ne doit être utilisée que pendant le travail par
des personnes conscientes des dangers et des moyens de minimiser ces dangers;
NON destiné à être utilisé dans une population générale / un environnement non
contrôlé.
– N'utilisez PAS la radio sans une antenne appropriée, car cela pourrait endommager
la radio et vous faire dépasser les limites d'exposition aux RF. Une antenne
appropriée est l'antenne fournie avec cette radio par le fabricant ou une antenne
spéci quement autorisée par le fabricant pour être utilisée avec cette radio.
– NE PAS transmettre pendant plus de 50% du temps total d'utilisation de la radio,
plus de 50% du temps peut entraîner un dépassement des exigences de
conformité à l'exposition aux RF.
ENGLISH
A-8
Advertisement
Table of Contents
