Troubleshooting - Pure Enrichment MistAire Studio User Manual

CLEANING (CONT'D)
If scale becomes difficult to remove with brush:
1. Fill the base with a mixture of 1 tsp. white vinegar and 1 tsp.
water.
2. Let the solution stand for 5 minutes.
3. While the vinegar is in the base, clean all of the interior surfaces
with a soft cloth or brush to help remove scale.
4. Check for buildup in the mist nozzle and mist tube. Clean as
needed.
5. Rinse the base thoroughly with water to remove scale and all of
the vinegar solution.
6. If minerals in your water are producing a white dust, you may
use a decalcification cartridge or humidifier cleaner cartridge to
keep the tank clean.
END OF SEASON STORAGE
• Follow the General Cleaning and Descaling instructions on
pages 8-9 to get your humidifier ready for storage at the end of
the season.
• Dry the humidifier completely before storing. DO NOT store with
water inside the base or water tank.
• Pack the unit in its original box and store in a cool, dry location.
NOTE: IF YOU EXPERIENCE A PROBLEM WITH THIS PRODUCT,
DO NOT ATTEMPT TO OPEN THE MOTOR HOUSING BY
YOURSELF. DOING SO MAY VOID YOUR WARRANTY AND
CAUSE DAMAGE TO THE HUMIDIFIER OR PERSONAL INJURY.

TROUBLESHOOTING

If you are having problems with your humidifier, see if one of the
solutions below resolves the problem before contacting Pure
Enrichment.
10 8
Problem Solution
Water vapor and Power plug: Unplug and then try again.
humidity are not being Power Failure: When power returns, try again.
produced. Tank Installation: Ensure tank is attached
properly.
Dirty ultrasonic disk: Clean disk (see page 9)
Air blows but water Excessive Water: Pour out extra water.
vapor is not produced. Residue inside tank: Wash tank and try again.
Dirty ultrasonic disk: Clean disk (see page 9)
If you use hard water, replace with softer water.
Dirty ultrasonic disk: Clean disk (see page 9)
Humidity level is low.
Water in unit is too cold: Replace with cool
water.
The humidity has a bad Poor maintenance or dirty water: Clean
smell. humidifier thoroughly, and fill with fresh water.
White dust is forming on Hard water may deposit dust: Dust in the air
nearby furniture. also settles because of added humidity in the
room. Use distilled water if it persists.
Humidifier has stopped No or low water: Unplug unit and refill tank.
working.
Water is accumulating Saturation of humidity: Lower mist control
outside of unit or area setting.
surrounding unit.
Unit not level and water is accumulating:
Unplug and place on level surface.
Point spray away from objects: Raise unit
on a water-resistant level surface 2-3 feet off of
floor.
Water dripping when Water remaining on bottom of tank: Wipe tank
refilling. or tilt to drain before transporting.
Increased noise level. Unit must be placed on a flat, level, hard
surface: Make sure it is NOT placed on a soft or
absorbent surface.
Red light on power dial. Red LED light indicates low water: Unplug
and refill tank.
11 9