Related Manuals for Quipall 3100GPW
Summary of Contents for Quipall 3100GPW
- Page 1 Model: 3100GPW Gasoline Pressure Washer OPERATOR'S MANUAL CPO Commerce, LLC 120 W. Bellevue Dr.,Pasadena, CA 91105 USA Quipall.com Customer service#: 1-866-577-3014 Email: customercare@quip-all.com...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Introduction ....................................3 Safety Rules .....................................4 Safety Symbols ................................4 Safety Instructions ...............................4 Pressure Washer Features ..............................7 Pressure Washer Parts Assembly............................8 Pressure Washer Parts List ..............................9 Assembly ....................................10 Packing List ................................10 Unpacking ...................................10 Attaching Foot Assembly............................11 Install Handle................................11 Attaching Upper and Lower Gun Hooks ........................11 Attaching Accessory Hook ............................11 Attaching Spray Gun..............................12 Adding Engine Oil and Fuel ............................13... -
Page 3: Introduction
INTRODUCTION Thank you for purchasing this superior quality pressure washer from Quipall . When operating and maintaining this ® product as instructed in this manual, your pressure washer will give you many years of reliable service. Product Specifications: This pressure washer operates at 3100PSI with a flow rate of 2.5 gallons per minute. This high end residential use system features a 212cc engine, no flat foam filled tires, 30’... -
Page 4: Safety Rules
SAFETY RULES Safety Symbols Indicates a potentially hazardous WARNING! situation which could result in serious injury or death if not avoided. Indicates a potentially hazardous CAUTION! situation which could result in damage to equipment or property. Slippery surface Risk of explosion Risk of electric shock Hot surface Eye protection... - Page 5 SAFETY RULES To reduce the risk of injection, injury or possible amputation, never direct water pressure towards people or pets. Moving parts can catch on clothing, jewelry, and hair. Pressure washer can create puddles and slippery surfaces. death. pressure builds up on the fuel cap, remove slowly. turned to the OFF position.
- Page 6 SAFETY RULES Stay alert and use common sense. Do not operate this unit if you are under the influence of alcohol, drugs, medication or you feel tired. Pull cord recoils rapidly and pulls arm towards engine faster than you can let go which could result in injury.
-
Page 7: Pressure Washer Features
PRESSURE WASHER FEATURES A - 30’ High Pressure Hose H - Locking Trigger B - Fuel Tank and cap I - Pull Cord C - Choke J - Engine ON/OFF Switch D - Fuel Valve Lever K - Oil Fill and Dipstick E - Soap Tank L - No Flat Foam Filled Tires F - Handle... -
Page 8: Pressure Washer Parts Assembly
PRESSURE WASHER PARTS ASSEMBLY... -
Page 9: Pressure Washer Parts List
PRESSURE WASHER PARTS LIST ITEM NAME ENGINE DH212 BOLT M6*40 SOAP TANK CAP SOAP TANK CAP FRAME BASE LOCK NUT M8 FOOT, FRAME ISOLATING BOLT M6 X 45 SWINGING ROD GASKET BRACKET,DOWN,GUN LOCK NUT M6 NUT M8 ENGINE MOUNT, VIBRATION ISOLATOR CHASSIS BACKPLANE WHEEL WHEEL AXLE... -
Page 10: Assembly
ASSEMBLY Packing List CARB Warranty Statement Sheet Spark Plug Wrench Do not attempt to assemble or operate this pressure washer until you have read and understood this entire manual. If you have any problems assembling or operating this unit Do not operate this pressure washer if any of the parts are damaged or missing until the part is replaced. -
Page 11: Attaching Foot Assembly
ASSEMBLY Attaching Foot Assembly (See fig 1) • Parts needed - 1 foot, 1 M8 lock nuts. • Raise or tilt pressure washer so you can line up foot with the hole located at the center of the frame. • Align the rubber foot with the hole in the frame where the foot is to be located. -
Page 12: Attaching Spray Gun
ASSEMBLY Attaching the Spray Gun (See fig 5 & 6) • Screw the spray wand and the trigger handle together until they are secure. • nut on by turning clockwise until it is hand tight. FIG 5 FIG 6... -
Page 13: Adding Engine Oil And Fuel
ASSEMBLY Adding / Checking Engine Oil (See fig 7) • Place pressure washer on a level surface. • • Carefully add between 520 ml (17.6 oz) of 4-Cycle engine oil (SAE10W30) to empty reservoir until oil reaches • Be sure to replace both dipsticks before attempting to start the engine. •... - Page 14 ASSEMBLY Connecting Garden Hose to Pressure Washer (See fig 9) • • Inspect inlet screen and remove any debris. • Connect hose to water inlet and tighten by hand. There must be a minimum of 10 feet of unrestricted hose between pressure washer and faucet or shut off valve.
-
Page 15: Operation
OPERATION Pre-Operation Check List • Read and understand this operator manual in its entirety before operating pressure washer. • Check oil level and add oil to the proper level if low. • Check fuel level and add fuel if needed. •... -
Page 16: How To Turn Off Pressure Washer
OPERATION Pull cord recoils rapidly and pulls arm towards engine faster than you can let go which WARNING! could result in injury. • Always relieve pressure from spray gun before pulling starter cord, including every failed attempt to start engine. •... -
Page 17: Using Spray Nozzle
OPERATION Using Spray Nozzle (See fig 16) • To connect or disconnect spray tip, pull back on the quick-connect collar. Insert or remove spray tip then release collar. • When spray tip is connected, pull on the spray tip to make sure it is secured. •... -
Page 18: Maintenance
MAINTENANCE Regular maintenance will extend the life of this pressure washer and improve its performance. The warranty does not cover items that result from operator negligence, misuse, or abuse. To receive full value from the warranty, operator must maintain the pressure washer as instructed in this manual, including proper storage. Before inspecting or servicing this machine, make sure the engine is OFF and no parts WARNING! are moving. -
Page 19: Changing Oil
MAINTENANCE Changing Engine Oil Checking Detergent Siphoning Tube Never repair high pressure hose or use unit if hose is damaged. If hose is damaged replace with identical Quipall part. ® High Pressure Hose Spray Gun Spray Nozzle... -
Page 20: How To Store
MAINTENANCE Checking Spark Plug • Disconnect the spark plug wire from the spark plug. • Before removing the spark plug, clean the area around its base to prevent debris from entering the engine. • Clean carbon deposits off the electrode with a wire brush. •... -
Page 21: Troubleshooting
TROUBLESHOOTING PROBLEM CAUSE SOLUTION Engine does not start 1. Out of fuel 1. Fill fuel tank 2. Engine oil low 2. Add engine oil 3. Spark plug wire disconnected 3. Connect spark plug wire from spark plug 4. Replace spark plug 4.