Table of Contents
Advertisement
Positioning and connecting
en
Before using the appliance for
the first time
The washing machine was thoroughly
tested before leaving the factory.To
remove any water that may be left over
from the test, run the first wash cycle
without any laundry.
Notes
The washing machine must be
■
correctly installed and connected.
From ~ Page 15
Never use a machine if it is
■
damaged. Inform the after-sales
service.
Preparatory work:
Check the machine.
1.
Remove the protective film from the
2.
control panel.
Plug in the mains plug.
3.
Turn on the tap.
4.
Running the programme without
laundry:
Switch on the appliance.
1.
Close the door (do not load any
2.
laundry).
Set the Drum Clean Û90 °C
3.
programme.
Open the detergent drawer.
4.
Pour approximately 1 litre of water
5.
into compartment II.
Pour standard washing powder into
6.
compartment II.
To prevent foaming, only use
Note:
half the amount of detergent
recommended by the detergent
manufacturer.Do not use detergents
intended for woollens or delicates.
Close the detergent drawer.
7.
Press the A button.
8.
Switch off the appliance at the end of
9.
the programme.
Your washing machine is now ready to
use.
22
Advertisement
Table of Contents
