Page 3
Phone: +1 614 543-8099 Fax: +1 614 430-5425 Information: balanceinfo@bertec.com Sales: balancesales@bertec.com Support: support@bertec.com www.bertecbalance.com Bertec’s authorized representative in the European Community: Emergo Europe Prinsessegracht 20 2514 AP The Hague The Netherlands Bertec Quick Reference Guide: Head Shake SOT 80P-0038...
Page 5
The User Manual should be your primary source of information. should not be used as such. The User Manual should be your primary source of information. Bertec Quick Reference Guide: Head Shake SOT 80P-0038...
Page 6
Bertec Quick Reference Guide: Head Shake SOT 80P-0038...
Contents of Head Shake SOT case Connecting Devices and Starting the Software Setting Up an Assessment Clinician Instructions Head Shake Scene Alignment Charging the Head Tracker Pairing Head Tracker and Receiver Head Tracker LED Status Lights Bertec Quick Reference Guide: Head Shake SOT 80P-0038...
Page 8
Bertec Quick Reference Guide: Head Shake SOT 80P-0038...
Page 9
Contents of the Head Shake SOT Case Headband USB charging cords Wall Charger Head Tracker Receiver Bertec Quick Reference Guide: Head Shake SOT 80P-0038...
Turn on the Head Tracker by sliding the switch on the side towards the LED. You may need to use a small thin object to flip the switch. Run Bertec Balance Advantage from the shortcut on the desktop. To log in, select an operator name, type in the password, and select Login.
Find the Head Shake SOT icon (shown below). Drag and drop the icon into the Test Series queue. Note: the icon will not be visible unless the Head Tracker is recognized by the software. Select ‘Start the Test Series’ Bertec Quick Reference Guide: Head Shake SOT 80P-0038...
Once the patient’s eyes are closed and head is moving at the correct speed, begin collecting data. Use the third button on the remote to start the trial. Note: If SOT was already completed that day, the first two conditions will be prepopulated and will not need to be retested. Bertec Quick Reference Guide: Head Shake SOT 80P-0038...
To recalibrate the head tracker, instruct the patient to look forward and reselect the condition. A properly aligned head tracker will show a scene where the blue ball is centered inside the larger circle. Bertec Quick Reference Guide: Head Shake SOT 80P-0038...
The minimum recommended charge level to perform a full assessment is no less than 25%. Note: If you charge the Head Tracker from a USB port on the computer, close the Balance Advantage software and keep the computer powered on and plugged in.
Intermediate battery displays are estimations of remaining charge. > Exiting Balance Advantage will halt communication between the Head Tracker and Receiver. Both devices will switch to solid blue LEDs If there is a communication issue during pairing, perform the following steps: >...
Red-Blue flashing Not paired when paired and communicating with the Receiver Blue flashing Communicating with Receiver Communicating with Head Tracker Blue solid Unit is on and unpaired Unit is plugged in and unpaired Bertec Quick Reference Guide: Head Shake SOT 80P-0038...
Page 17
Bertec Quick Reference Guide: Head Shake SOT 80P-0038...
Page 18
Bertec Corporation 2500 Citygate Drive Columbus, Ohio 43219 U.S.A. t + 1 614 543-8099 f + 1 614 430-5425 www.bertecbalance.com We Bring Balance to Lives ®...
Need help?
Do you have a question about the Balance Advantage and is the answer not in the manual?
Questions and answers