Canon ZR100 Instruction Manual page 81

Canon instruction manual digital video camcorder zr100
Hide thumbs Also See for ZR100:
Table of Contents

Advertisement

Lithium Button Battery Handling Precautions
WARNING!
• The battery used in this device may present a fire or chemical burn hazard if
mistreated. Do not recharge, disassemble, heat above 100 °C (212 °F) or incinerate
the battery.
• Replace the battery with a CR1616 made by Panasonic, Hitachi Maxell, Sony,
Toshiba, Varta or Renata. Use of other batteries may present a risk of fire or
explosion.
Do not pick up the battery using tweezers or other metal tools as this will cause a short
circuit.
Wipe the battery with a clean dry cloth to ensure proper contact.
Keep the battery out of reach of children. If it is swallowed, seek medical assistance
immediately. The battery case may break and the battery fluids may damage stomach
and intestines.
Do not disassemble, heat or immerse the battery in water to avoid the risk of explosion.
Cassette Handling Precautions
Rewind tapes after use. If the tape becomes slack and damaged, it may cause picture
and sound distortion.
Return cassettes in the case and store them upright.
Do not leave the cassette in the camcorder after use.
Do not use spliced tapes or nonstandard cassettes as they may damage the
camcorder.
Do not use tapes that have been jammed as video heads may become dirty.
Do not insert anything into the small holes of the cassette, or cover them with
cellophane tape.
Handle cassettes with care. Do not drop or subject them to severe impact as this may
damage the cassettes.
Rewind tapes from time to time if they are stored for a long time.
With cassettes equipped with a memory function, metal plated terminals may become
dirty with use. Clean the terminals with a cotton swab after about 10 times of loading/
unloading. The memory function is not supported by the camcorder.
Protecting Tapes from Accidental Erasure
To protect your recordings from accidental
erasure, slide the tab on the cassette to the
left. (This switch position is usually labeled
SAVE or ERASE OFF.)
If you load a protected cassette in CAMERA
mode, the message "THE TAPE IS SET FOR
ERASURE PREVENTION" appears for
approx. 4 seconds and "
you wish to record on that cassette, slide the tab back to the right.
" starts flashing. If
REC
SAVE
E
REC
SAVE
81

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents