AEG SFB58211AF User Manual page 11

Problem
There is too much frost and
ice.
Water flows on the rear plate
of the refrigerator.
Water flows into the refriger-
ator.
Water flows on the floor.
The temperature in the ap-
pliance is too low/too high.
There is too much con-
densed water on the rear
wall of the refrigerator.
Possible cause
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not wrap-
ped properly.
Temperature is set incorrect-
ly.
During the automatic de-
frosting process, frost melts
on the rear plate.
The water outlet is clogged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
Door was opened too fre-
quently.
Door was not closed com-
pletely.
ENGLISH
Solution
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products bet-
ter.
Refer to "Operation" chap-
ter.
This is correct.
Clean the water outlet.
Make sure that food prod-
ucts do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces-
sary.
Open the door only when
necessary.
Make sure the door is closed
completely.
11