PerTronix T3001 Quick Start Manual

PerTronix Quick Change Ratchet Crimp Kit
Contents:
1 - 9" Quick Change Ratchet Crimp Tool
1 - (A) Insulated Crimp Die
1 - (B) Non-Insulated Crimp Die
1 - (C) Open Barrel Crimp Die
1 - (H) Open Barrel D-Sub Die
1 - (H1) Spark Plug Wire Die
Using the tool
Place the terminal to be crimped so that the wire
receiving end points to the left and the terminal
end points to the right. Slowly squeeze the tool
handles so that the terminal is held in place with-
out crimping the terminal. The Crimp portion of
the terminal should be flush with the right side of
the crimp die. Insert the bare wire into the terminal
and squeeze the tool handles until the tool returns
to the open position. If for any reason the ratchet
mechanism needs to be released mid cycle, press
the release lever, located between the handles, forward.
Release Lever