Samsung harman/kardon HWQ90RXY Full Manual page 32

Table of Contents

Advertisement


Sound Control
PAIR
SOUND
SOUND
MODE
MODE

VOL
WOOFER
WOOFER
VOL
SOUND
MODE

VOL
VOL
You can select TREBLE, BASS, SYNC, CENTER LEVEL, SIDE LEVEL, FRONT TOP LEVEL,
REAR LEVEL, REAR TOP LEVEL, and VIRTUAL ON/OFF.
– To control the volume of the treble or bass sound, select TREBLE or BASS in Sound
Settings, and then adjust the volume between -6~+6 by using the Up/Down buttons.
– Press and hold the
for each frequency band. 150Hz, 300Hz, 600Hz, 1.2kHz, 2.5kHz, 5kHz, and 10kHz are
selectable using the Left/Right buttons and each can be adjusted to a setting
between -6 to +6 using the Up/Down buttons.
– To control the volume of the each speaker select CENTER LEVEL, SIDE LEVEL or
FRONT TOP LEVEL in Sound Settings, and then adjust the volume between -6~+6 by
using the Up/Down buttons.
– If the video on the TV and audio from the Soundbar are not synchronised, select SYNC
in Sound Control, and then set the audio delay between 0~300 milliseconds by using
the Up/Down buttons.
– If Surround Speakers are connected, select REAR LEVEL or REAR TOP LEVEL, and
then use the Up/Down buttons to adjust the volume within a -6 to +6 range.
PAIR
The VIRTUAL Speaker function can be turned ON/OFF by using the Up/Down
buttons.
– SYNC is only supported for some functions.
• Initialise
With the Soundbar turned off, press and hold the
than 5 seconds until the speaker turns on. "INIT" appears on the display and the
Soundbar is initialised.
PAIR
WOOFER
Push the button up or down to adjust the volume of the subwoofer to -12 or between -6 to
+6. To set the subwoofer volume level to 0, press the button.
WOOFER
Push the button up or down to adjust the volume.
• Mute
Press the VOL button to mute the sound. Press it again to unmute the sound.
(Sound Control) button for about 5 seconds to adjust the sound
ENG - 28
(Sound Control) button for more

Advertisement

Table of Contents
loading

This manual is also suitable for:

Harman/kardon hw-q90r

Table of Contents