Basics; Choosing Tone Or Pulse Dialing; Making And Receiving Calls - Lenoxx Sound PH-549 Operating Instructions Manual

GETTING STARTED
Step 4: Setting up the Telephone (Continued)
SETTING UP LANGUAGE, AREA CODE, TIME AND DATE (Continued)
Your phone will now go to the Time and Date mode, press the UP and DOWN buttons to get
to the correct number and the DELETE button to accept.
You do not have to set up the Time and Date because the telephone company will auto-
matically update this with your Caller ID when your phone rings (twice or more). To get back
to the standby mode (for dialing), press the DELETE button until the normal display shows
(see below for example):
(Example: 10:53 a.m. On June 18th)
TO RESET THE PHONE
In the rare case of abnormal telephone line interference, your phone may not work properly
and may need to be reset. Make sure the phone is hung up, use a pointed object like a
straightened paper clip and stick it into the small hole at the bottom of the phone (marked
RESET) for 2 seconds. The display will return to the setup mode.
You will need to reprogram the memory numbers you stored.

BASICS

Choosing Tone or Pulse Dialing

Select the type of dialing that you desire or that your telephone system requires by setting
the TONE/PULSE switch.
TONE - The set will operate using tone dialing.
PULSE - The set will dial using rotary dial type pulses (clicking sounds).
If you are not sure of your dialing system, make a trial call with the switch set to TONE. If the
call connects, leave the switch as it is; otherwise, set it to PULSE.
NOTE: To use caller ID service, you will probably need TONE dialing.
Even when your phone is set to pulse service, this phone can be switched to temporary
tone for access to services that require tone signaling including Telephone Banking. Just
press the TONE
tone signaling for this call only.

Making and Receiving Calls

MAKING A CALL
1. Pick up the handset to get a dial tone. The hook icon
2. Dial the phone number. The dialed number appears on the display.
3. When you finished talking, replace the handset into the base.
RECEIVING A CALL
1. Pick up the handset when the phone rings. The hook icon
2. After a few seconds, the Count up timer will start.
3. When you finished talking, replace the handset into the base.
All manuals and user guides at all-guides.com
button after dialing in pulse and your buttons can now be used for
will show in the display.
8
will show.
PH-549042100RTTv.2 E