BEFORE OPERATING ANY EQUIPMENT, READ AND FAMILIARIZE YOURSELF WITH THESE USE AND SAFETY INSTRUCTIONS Congratulations on your purchase of this SPECTRUM commercial equipment. When used as intended, and with proper care and maintenance, you are sure to experience years of reliable operation from this equipment. To ensure best results, it is important that you read and follow the instructions in this manual carefully.
A. Apparent damage or loss must be noted on the freight bill SPECTRUM will not accept liability for the following if: at the time of delivery. It must then be signed by the carrier • The instructions in this manual have not been followed correctly.
1. Remove all packing materials and tape, as well as any protective plastic and cardboard, from the unit. SPECTRUM prides itself on quality and service, ensuring that at the 2. Clean any glue residue left over from the plastic or tape.
Important Safeguards These instructions should be followed at all times. Failure to follow 10. This appliance should always be on a stable and steady countertop these instructions could result in injury to yourself and others. or table. Allow sufficient space around the cooking area. Never use the unit on/near low-heat-resistant materials (carpet, vinyl).
E. Fault Indicator Light J. "ON/OFF" Button Note ® The WINCO Spectrum Commercial Induction Cooker has three (3) different cooking modes: (G) Timer Mode, (H) Temperature Mode, (I) Power Mode. Note Induction Cookers require induction-ready cookware. Power Mode (Wattage) Temperature Mode 1.
The SPECTRUM™ Commercial Induction Cooker should be cleaned after each day’s operation; however, the unit may However, there is no guarantee that interference will require more frequent cleaning, depending on the volume not occur in a particular installation.
Troubleshooting If the SPECTRUM™ Commercial Induction Cooker does not operate, please check the following before placing a service call: ERROR CODES DESCRIPTION OF ERROR RECOMMENDED SOLUTION Check the wire connection between the main PCB board and display control board. EC/E16 Main board cannot connect with control panel.
LINK MAIN BOARD SENSOR Control board This circuit diagram has been provided to assist qualified electricians; only SPECTRUM™ service agents or qualified electricians should carry out repairs if required. Do not remove any components or service panels on this product.
Limited Warranty WARRANTY SERVICE WINCO® warrants to the original purchaser of new equipment that said equipment, when installed in accordance with our instructions within To initiate warranty service North America and subjected to normal use, is free from defects in email: EquipService@wincous.com or call: 973-295-3899 material or workmanship for a period of 1 year.