USB-High Speed Serial Converter
User's Manual
Model ATC-810
Overview
Congratulations on your purchase of the ATC's USB-high
Speed Serial Converter. This device provides a simple and
easy way to connect Universal Serial Bus (USB) and
Serial port interface. With the advantage of USB port,
users have the capability to utilize the peripheral with serial
port interface in an easy to use environment such as plug
and play & hot swap function. This adapter is designed for
ideal connections to Cellular Phone, Digital Camera,
Modems or ISDN terminal adapter with over 1Mbps data
transfer rate.
The USB-high Speed Serial Converter and software
drivers are capable of providing a no-firmware-change
feature that enable USB interface to be transparent to
serial port peripherals with minimum modifications.
Package Content
Hardware: USB-High Speed Serial Converter
Software: USB-High Speed Serial Converter
driver on CD-ROM
User's Manual
Product Features
USB Specification Rev. 1.1,2.0 compliant
Support the RS232 Serial interface
Over 460Kbps data transfer rate
Support remote wake-up and power
management
DB9 male Pin Assignment: (
Figure 1)
Figure 1
RS-232 Pinout (DB9 Male DTE)
PIN
Signal Name
1
DCD (Data Carrier Detect)
2
RXD (Receive Data)
3
TXD (Transmit Data)
4
DTR (DTE Ready)
5
GND (Ground)
6
DSR (DCE Ready)
7
RTS (Request to Send
8
CTS (Clear to Send)
9
RI (Ring Indicator)
LED indication
Red LED ----- Data Sending From USB port to RS-232
Green LED ----Data Receiving from RS-232 Serial port
side to USB port
System Requirements
IBM PC 486DX4-100 MHz CPU or higher or
compatible system
Available USB port
CD-ROM drive
Windows 98. Windows 2000 .Windows XP.Vista
Windows 7/8/10,Win CE or IMAG
Driver Installation
Follow the steps below to install driver of USB-High Speed
Serial Converter:
1.
Power on your computer and make sure that the USB
port is enabled and working properly.
2.
Plug in the USB-High Speed Serial Converter into the
USB port and run the Add New Hardware Wizard to
assist you in setting up the new device. Click Next to
continue.
3.
Insert the USB-HS Serial Converter software driver
RS-232
into the CD-ROM drive and click Next to continue. For
Signals
Windows 98, click Search for the best driver for
Input
your device and click to search driver from the floppy
Input
Output
drive D:\DRIVER\Win98&Win2000.
Output
Ground
Input
Output
Input
Input
Serial Port side