Advertisement
Before cutting holes in the sides of the enclosure, verify all
internal components are clear of the cutting tool to avoid
damaging installed components.
INSTALLATION INSTRUCTIONS
1.
Apply cutout template to the side of the enclosure located as desired.
See Figure 1
2.
Cutout hole in enclosure using the appropriate cutout size for the model you
purchased.
3.
Deburr the cutting edge.
4.
Insert fan or grille and push into opening until snapped and locked.
See Figure 2.
5.
Mounting fasteners are not required for panel or enclosure material thickness less
than .10 (2.5 mm). For panel or enclosure material thickness between .10 (2.5 mm)
and .14 (3.5 mm), mounting fasteners are recommended. For panel or enclosure
material thickness greater than .14 (3.5 mm), mounting fasteners are required in
order to maintain the IP / Type 12 rating.
6.
In order to install the mounting fasteners, removal of the grille is required. Remove
the grille by pulling from the top of the grille to 45° maximum as shown in Figure 3
on page 4. Then pull from the bottom as shown in Figure 4 on page 4.
NOTE: The orientation "Top" directs the louvers downward. This is for reference
only; the assembly can be installed to orient louvers in any direction.
7.
It may be necessary to drill out the mounting holes in the filter housing. For model
HF04, use a 1/8 (3 mm) drill bit. For models HF05, HF09, HF10 and HF13, use a
5/32 (4 mm) drill bit.
8.
Torque fasteners to 20-25 in-lbs (2.3-2.8 Nm). See Figure 5 on page 4.
9.
Install the grille as shown in Figure 2
10. Verify the location of the enclosure with installed filter fan has a minimum clearance of
7.00 (178 mm). See Figure 7 on page 4
11. Wire the filter fan following the Wire Diagrams on page 5 for the appropriate model
being installed.
Figure 1
89137856
All manuals and user guides at all-guides.com
CAUTION
© 2017 Pentair Equipment Protection
Figure 2
- 3 -
Advertisement
