Bosch WAW28440AU Instruction Manual And Installation Instructions page 50

Faults and what to do about them.
en
Faults
Odours in the washing
machine.
The Å symbol lights up
in the display panel. Foam
may also be leaking from
the detergent drawer.
Loud noises, vibrations
and machine "movement"
during the spin cycle.
The display panel/
indicator lamps do not
work while the appliance
is running.
There is detergent
residue on the laundry.
- P - appears in the
display panel when the
cycle is paused.
- P - and ÿ appear in the
display panel when the
cycle is paused.
If you cannot rectify a fault yourself (after switching the machine off and on again) or a repair is required:
Switch off the appliance and pull out the mains plug.
■
Turn off the tap and call customer services.
■
50
Cause/Remedy
Run the Û Drum Clean 90 °C programme without laundry.
Add washing powder or a detergent containing bleach.
Note: . To prevent foaming, only use half of the amount of detergent
recommended by the detergent manufacturer. Do not use detergents designed
for woollens or delicates.
Have you used too much detergent?
Mix one tablespoon of fabric softener with 1/2 litre of water and pour it into
compartment II (not suitable for outdoor clothing, sportswear or items stuffed
with down).
Use less detergent in the next washing cycle.
Is the appliance aligned? Align the appliance. ~ Page 20
■
Are the appliance's feet fixed? Secure the appliance's feet. ~ Page 20
■
Have the transport braces been removed? Remove the transport braces.
■
~ Page 16
Has there been a power failure?
■
Have the fuses blown? Reset/replace the fuses.
■
If the fault occurs repeatedly, call customer services.
■
Some phosphate-free detergents contain water-insoluble residue.
■
Select O Rinse or brush the laundry after washing.
■
The water level is too high. It is not possible to add laundry. Close the door
■
immediately, if necessary.
Press the A button to continue the programme.
■
The door is unlocked. It is possible to add laundry.