Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for Avalon SteriTech GAMBIT
- Page 1 Quick Start Guide...
-
Page 2: Table Of Contents
Machine Overview Charging Instructions 04 - 05 Solution Filling & Draining 06 - 07 Machine Setup with Whiz 08 - 09 Operation Modes Maintenance... -
Page 3: Machine Overview
Machine Overview Solution filler door Filler port filter Battery level indicator LED light Spraying nozzle manual activation button Spraying nozzle Housing enclosure Gambit system power button Solution level Side latch (Right) indicator LED light Side latch (Left) Power Charging Part Charging port cover Swivel casters (x4) Motion sensor... -
Page 4: Charging Instructions
Charging Instructions Attach the power cord to the power charger Check to ensure the voltage selector on the power On/Off charger is properly set to 110V or 230V and power button on the power charger is in the off position Voltage Selector Attach the power cord to the wall outlet... - Page 5 To stop charging, switch off the power charger by pressing the power button to the off position Eject Button Press and hold the eject button on the Gambit system. Gently pull on the power cord connector to remove the charging connector Unplug the power charger from the wall outlet...
-
Page 6: Solution Filling & Draining
Solution Filling & Draining Filling Instructions The Gambit system should be switched off and detached from Whiz Ensure the Gambit system is not connected to the power charger Drain the solution tank until it is empty. Then Closed turn the drainage valve to its closed position Drain Flip open the solution filler door Slowly fill the Gambit system with approved chemicals /... - Page 7 Solution Filling & Draining Draining Instructions The Gambit system should be switched off and detached from Whiz It is not connected to the power charger Open the magnetic solution drainage door Take out the solution drainage tube and insert into an appropriate container. Rotate the drainage valve anticlockwise by 90 degrees to drain After drainage is completed, rotate the drainage valve clockwise by 90 degrees to close.
-
Page 8: Machine Setup With Whiz
Machine Setup with Whiz Assembly Instructions Check that the bottom latch hold-down knob is in the unlocked position Ensure Whiz is switched on Align the Gambit with Whiz, hold the top part of Whiz with one hand and hold Gambit with another hand, and push the two units together Lift the Whiz handle slightly to let the top housing of Gambit pass under handle and then release... - Page 9 Machine Setup with Whiz Disassembly Instructions Ensure the Whiz handle is down (with auto brake engaged) Lift bottom latch up and rotate the bottom latch hold-down knob in a counter-clockwise fashion Press and hold both side latches Pull the Gambit system backwards to decouple from the Whiz Reset the Gambit system’s bottom latch by rotating the bottom latch hold-down knob...
-
Page 10: Operation Modes
Operation Modes Set the nozzle angle via the handle before operation Ensure the Whiz is switched on and couple the Gambit system to Whiz Turn on the Gambit system by pressing the power button Power Wait 50 seconds for the Gambit system’s automatic boot up sequence to initiate. -
Page 11: Maintenance
Maintenance (Daily) The Gambit system should be switched off and detached from Whiz Ensure Gambit is not connected to the power charger Inspect the casters and clean off debris with damp cloth Inspect the solution filler for solids and debris build up Wipe the entire Gambit system housing with a damp cloth... - Page 12 Maintenance (Periodic) The Gambit system should be switched off and detached from Whiz Ensure Gambit is not connected to the power charger Inspect the casters and clean off debris with damp cloth Drain the solution tank until it is empty. Then turn the drainage valve to closed position Lay the Gambit system on a soft and cushioned surface, take extra care of the control panel and...
- Page 13 Fill the solution tank with 500 mL of distilled water Power on the Gambit system and press Spray the manual spray button to activate spraying. Power Spray Once the distilled water is completely depleted, press the manual spray activation button to stop the Gambit system Power off the Gambit system Power...
Need help?
Do you have a question about the SteriTech GAMBIT and is the answer not in the manual?
Questions and answers