Por favor, certifique-se de que este cabo de energia está ligado firmemente à sua CLEARANCE AND DIMENSIONS unidade CookTek ANTES de ligar a unidade à tomada de energia e antes de tentar funcionar com ela. Clearance: Be sure to allow for a minimum clearance of 2” (51 mm) between all sides of the housing and any surface or obstacle, and 6”...
0,5 cm, aby umożliwić obieg powietrza. outlet is blocked, the internal temperature will rise, causing an error code to occur. • Please make sure that the power cord is firmly attached to your CookTek unit Dla bezpieczeństwa użytkownika nie wolno nigdy przecinać, wyjmować ani wyłączać...
CookTek PRIMA di collegare l’unità alla presa elettrica e prima di metterla in funzione. The CookTek Stock Pot Heater (MSP) has a single knob for setting the power from • Non toccare la piastra di ceramica (o la superficie del piano cottura) subito dopo 1-10.
GREEK CARE AND CLEANING Πριν θέσετε το Cooktop σας σε λειτουργία, εκτελέστε τα ακόλουθα: Your CookTek induction stock pot heater is easy to keep clean. Be sure to follow • Αφαιρέστε όλα τα υλικά συσκευασίας. these easy instructions: • Τοποθετήστε τη μονάδα σε μια στεγνή, επίπεδη, σκληρή, σταθερή και μη εύφλεκτη...
Page 6
• DO NOT overcook food or leave the appliance unattended while in use. un membre du personnel de CookTek. Ne jamais essayer d’ouvrir l’appareil ni de • In the unlikely event of a grease fire, smother flame by covering cookware with a le réparer.
• Dit product mag uitsluitend worden gerepareerd door een geautoriseerd WARRANTy STATEMENT servicebedrijf of door personeel van CookTek. Probeer niet om het toestel open te maken of op enige wijze te repareren. Neem voor informatie over onderhoud en Please visit www.cooktek.com/warranty-service for CookTek Warranty information.
TROUbLESHOOTING ERROR CODES In the event of a possible malfunction, your CookTek stock pot heater will flash an Symptom Possible Cause Possible Solution error code on the LED display. Please consult the following table when encountering No power (no • Unit unplugged.
Need help?
Do you have a question about the MSP7000-200 and is the answer not in the manual?
Questions and answers