Related Manuals for Ericsson KRY 101 1613
Summary of Contents for Ericsson KRY 101 1613
- Page 1 All manuals and user guides at all-guides.com Installation Manual VEHICLE HANDSFREE KIT KRY 101 1613 ericssonz...
-
Page 2: Table Of Contents
Ericsson Inc., at any time and without notice. Such changes will be incorporated into new editions of this manual. No part of this manual may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying and recording, for any purpose, without the express written permission of Ericsson Inc. -
Page 3: General
All manuals and user guides at all-guides.com • The kit includes the following GENERAL • Handsfree cradle VEHICLE HANDSFREE • Mounting brackets provides for the safe and easy use of the • DPE-100 portable radio in a vehicle. Microphone and clip •... -
Page 4: Wiring To An External Antenna
All manuals and user guides at all-guides.com 1. Remove the plastic insert from the WIRING TO AN EXTERNAL ANTENNA antenna connection hole at the top An external antenna (to be purchased back of the cradle. separately) greatly improves performance. 2. Push the long connector on the antenna cable through the hole. -
Page 5: Mounting The Cradle
All manuals and user guides at all-guides.com MOUNTING THE CRADLE steps attach the Follow the below to cradle swivel mount to the Locate the cradle within reach of driver easy where obstruct driving. will SWIVEL MOUNT Place the swivel joint into desired position and mark the drilling area using the holes as a template. -
Page 6: Wiring To The Vehicle'sbattery
All manuals and user guides at all-guides.com mount and loosely attach with the nut WIRING TO THE VEHICLE'S BATTERY and the back of the pocket mount. Cut a short 6 - 8 inch length of red 2. Place the unit on the drilled holes and wire from the power cable. -
Page 7: Mounting The Microphone
All manuals and user guides at all-guides.com MOUNTING THE MICROPHONE 1. Locate the microphone out-of-the-way about 8-12 inches from the driver's face and away from windows or other sources of noise. Use the visor clip or adhesive strip mount microphone. ALWAYS VISOR CLIP IF POSSIBLE. -
Page 8: Inserting And Removing The Radio
All manuals and user guides at all-guides.com If the battery is medium, fold out the support before inserting the radio. NOTE INSERTING THE RADIO Be especially careful not to pull the mike cable or poke it with installation tools. 1. Find the small grooves on the sides of the radio at the bottom, and align them with the guides in the base of INSERTING AND REMOVING THE... -
Page 9: Specifications
All manuals and user guides at all-guides.com 2. With the base of the radio in place, REMOVING THE RADIO gently push the top back into the Gently pull out on the top of the radio cradle until you feel it snap in. until you feel it loosen, then remove the phone. -
Page 10: Troubleshooting
All manuals and user guides at all-guides.com TROUBLESHOOTING RADIO PROBLEM PROBABLE CAUSES SOLUTION • cradle is wired to a switchable • if wired to the ignition switch, VEHICLE HANDSFREE unit does not receive vehicle power source that is turned off ignition may need to be turned on power •... - Page 11 All manuals and user guides at all-guides.com This page intentionally left blank...
- Page 12 All manuals and user guides at all-guides.com Ericsson Inc. Private Radio Systems Mountain View Road Lynchburg, Virginia 24502 AE/LZT 123 1881 R1A 1-800-528-7711 (Outside USA, 804-528-7711) Printed in U.S.A.
Need help?
Do you have a question about the KRY 101 1613 and is the answer not in the manual?
Questions and answers