Table of Contents
Advertisement
All manuals and user guides at all-guides.com
To start the demonstration mode
• Press and hold Ç (on the system only)
for 5 seconds when the system is in
standby mode.
™ The demonstration will begin.
Easy Set
EASY SET allows you to store all available
radio stations and RDS stations
automatically.
1 Press and hold STANDBY ON (on the
system only) for 5 seconds ; when the
system is in standby or demonstration
mode.
™ "EASY SET" will be displayed, and
followed by "TUNER" and then
"AUTO".
™ EASY SET will start searching for all
RDS radio stations with sufficient
signal strength and then followed by
radio stations on FM, MW and LW
band respectively. Weak RDS radio
stations may be stored in later
presets.
™ All available RDS and radio stations
with sufficient signal strength will be
stored. Up to 40 presets may be
stored.
2 The system will proceed to set the RDS
time automatically with the stored RDS
preset station.
• If no RDS station is available in the first
preset station, the program will exit
automatically.
pg 01-29/C85-C83/22-Eng
11
™ After a radio station is found, "EASY
Switching the system to
SET" will be displayed and followed
standby mode
by "TIME".
• Press STANDBY ON or B on the
• When searching RDS time;
™ "SEARCH RDS TIME" will be
remote control.
™ The system will switch to standby
displayed.
™ When RDS time is read, "RDS
TIME" will be displayed. The current
time will be displayed for 2 seconds
Switching the system to power
and stored automatically.
save mode
Notes:
is stopped)
– EASY SET will start with the RDS
• Press POWER SAVE to switch to
station, if there are still presets
energy saving mode ( < 2 watts ).
available, it will continue to store the
™ "LOW POWER STANDBY ON" will
FM, MW and LW bands respectively.
– When EASY SET is used, all previously
stored radio stations will be replaced.
™ The low power STANDBY ON LED
– The last preset radio station or the first
available RDS station will appear on the
Note:
display when EASY SET is completed.
– if the demonstration mode has not been
– If RDS station does not transmit RDS
disabled, it will resume 5 seconds later.
time within 90 seconds, the program
will exit automatically and the display
will show " NO RDS TIME ".
Selecting the Source
• Press the respective source selection
Switching the system ON
button: CD, TUNER, TAPE or AUX.
™ The display indicates the selected
• Press CD, TUNER, TAPE or AUX.
You can also switch on the system by
Note:
pressing any one of the CD DIRECT PLAY
– For an external source, make sure you
buttons.
have connected the audio left and right
OUT terminals of the external
equipment (TV, VCR, Laser Disc player,
DVD player or CD Recorder) to the AUX/
CDR IN terminals.
OPERATING THE SYSTEM
Dim mode
You can select the desired brightness for
the display.
• Press DIM to select DIM 1, DIM 2, DIM
3 or DIM OFF display mode.
mode.
™ The
™ "DIM 1", "DIM 2", "DIM 3" or
"DIM OFF" will be displayed
depending on the mode selected.
(when Demonstration mode
DIM OFF - normal brightness with
Spectrum Analyzer On
be displayed, after which the display
screen goes blank.
will be lit.
DIM 1 - normal brightness with
Spectrum Analyzer Off
DIM 2 - half brightness with Spectrum
Analyzer On
source.
3/6/00, 1:00 PM
appears on the display.
DIM
11
3139 116 19611
Advertisement
Table of Contents
